Switches - Small Business

ネットワーク初級者です。WS-C2960Sでスタックを組んでいるのですが、switchコマンドなどで設定した「メンバ番号」や「プライオリティ」などの設定情報はどこに保存されるのでしょうか？startup-configなどには（表面上）保存されていないかと思いますが、いったいどこにあるのか・・・悩み中です

I have 3 2960g switches that each have about 40 devices (pc's, printers, etc..) attached to them.  Each of these 2960 switches has one port connected to a port on a  "core" switch, which is a 3950g.  The 3950 has 3 switches and all of our servers (12...

Hello Cisco Support Community, First thank you for any replies.The video posted today on 302's and multiple VLAN's on one switch was nice.Thank you, I have that working but it's not really what I need.Though pictures are worth a 1000 words so I hope ...

Hi Guys,Last week and just yesterday, our switch SG200 50/50 logged an error like this:%CDP-E-MALFORMED_TLV: CDP message from 88:43:e1:ab:66:f8 cached with illegal Appliance VLAN-ID TLV  At the time of the error, the SA520 router's LAN Port 1 where t...

  Any assistance would be very much appreciated.

My question is..interface Gi0/1 on access switch (Switch A) configured as trunk port allowing multiple vlans (say vlan 100-105)Now, this interface Gi0/1 on switch A has no issues and configured fine. Another switch B connected to Switch A and workin...

Hi folks,I  am new to the whole VLAN thing, so excuse my ignorance. I have  successfully set up a VLAN on my primary switch which is an SGE2010. I  have 3 other switches is other buildings connected in series. The next  in line is another SGE2010 and...

Usually with servers and all I'm gung ho about updating firmware as it fixes problems. But really never mucked too much with switch firmware. We just got a SG200-18 new from Dell as they sell Cisco stuff. It came with 1.0.0.19 firmware version. But I...

Hi,Is also the SR2024T-EU EOL?

I recently purchased a SF 100D  5 port switch, that is frustrating me.  I currently have a New dell PC connected through a wall jack to an existing router, and wanted to add an ethernet printer.  When I connect everything to the switch, I can only ge...

We just purchased 8 managed switches POE to swap out our existing in preparation for our new phone system.  We installed them all after configuring with static IP.  Deployed... and all but two work fine.  Can someone assist with tips for troubleshoot...