Switches - Small Business

SGE2000 problems:1) Layer 3 stack routing (?) problem after slave unit restarts.Greetings!Firmware: 3.0.0.18Boot code: 20003The scheme:----- LAN1         SGE2000 Level 3 stack:               `-----------Unit 2 (slave)                           Unit 1...

Started the setup wizard and "connected to switchI got two windows that popped up1Check security Settings to make sure cyrrent Java Virtual Machine is not prevented from running comands2Failed to get Default gatewayI followed directions, I am not on ...

Hi,I'm facing a problem with ACL binding on SRW224G4 and SRW248G4. I've got one MAC based ACL where I want to add or delete a MAC from time to time, bind the ACL back to appropriate ports and save settings. During this step I receive an error message...

I have two SRW2008 switches that I am configuring for use. I changed the IP addresses and the admin passwords on both. I had to re-login after the IP addresses changed and the new passwords worked. I just found out that ANY password works for the adm...

HelloI have a  sf 302-08, and I wonder does this switch support inter-vlan routing, because I need to setup 3 vlan with different Ip address and also share some resources of the network.Thanks

My work just bought this switch last week. The switch was brand new when I opended the box.The web GUI on the switch never fully opens so that it's functional. On each browser that I try the page only loads halfway... It seems the iframe content neve...

I am looking to connect a SGE2000P switch to an existing infrastructure. I am unable to locate any information in the literature specifying compatible SFP adaptors. I require to connect to MMF 1350nm 100BASE-FX?

I was reconfiguring this switch and taking LAG/LACP off of Gi1 and Gi2.   After I did this I am unable to hit the web interface.  I have also  tried connecting to the switch with a serial cable, with 38400 8 n 1 n,  and cannot bring up the console. A...

Hi,We have 3 ESW-520-24P series switches.I can not console them because by default they have a security profile attached into it for "Console Only" and It is set as "Deny".I can't modify or delete it because it's a default security policy.We can do c...

I have a total of 4 buildings and ultimately will have approximately 600-750 devices connected to my network.  Currently I have SGE2010's and SGE2000p's  installed at the edge and a stack of 3 SGE2010's serving as the core switch.  The core and edges...

We recently purchased some of the ESW-540 Cisco switches for some lower end access ports.  I'd like to script the configuration backup using Kiwicat if possible, but haven't figured out how to either get into the cli, or config kiwicat to backup via ...

Hi,Is there an API for SRW208MP 8 port 10/100 (POE) that I can access via C# code for example?Awating your help and thak you

I have a Linksys SRW2016, i don't remember de IP address that I assigned to the switch and I don't have the serial cable that came with the switch with me.I tried with a generic cable but it doesn't work at all and I really need to make this switch w...