hello communityone of our customer has given us a requirement like if computer is idle for let say 5 mins or if user is not at hie/her desk. the switch port connected to that computer should go in administrative down mode and should come up only by m...
Forum Posts
I’m in need of some serious assistance. I have scoured the forums, but can’t quite put together the information I need to resolve my issue. I thought I was a little better than a novice, but I have much more practicing to do My current setup is as fo...
Hi Cisco Community I would like to upgrade IOS-XE version 16.6.4 to 16.9.1. I'm not sure between upgrade version I'm must be to upgrade ROMMON version ? And I'm not find procedure in download software page.
Hello All, I've been trying to disable Unknown multicast blocked: enabled for some reason can't get it to change on any port, is happening on all 96 ports, not sure if there's a global setting or feature that needs to be activated perhaps a license w...
Can someone please confirm if QSFP-10G breakout cables are supported on 9500-24QA ? I saw the documentation, and it says it is supported on 9500-32YC, but also gives breakout specifications for other switches like 24 QA. https://www.cisco.com/c/en/us...
All, We recently purchased a Cisco 9407 switch with two supervisor modules and four Ethernet line cards. I am currently configuring the switch in our test site. The switch will then be taken to the production site. My question is since I configure al...
Yesterday, I configured a 2960C switch to make part of my lab. Initially, I created a VLAN...an SVI for that VLAN and assigned it an IP Address...assigned an access port to that VLAN...and, configured a default gateway. I connected my laptop to the a...
when the equipment is polled with the collector and we are identifying a stack of several switches, it is possible to identify the ip of the stack but the other devices do not appear.
Resolved! IPsec tunnel connection/ping problem
Hello colleagues! I'm begginer and was facing with small project(pkt attached) for a few days, but I gave up.The problem i can't fix is just can't from outside network (172.16.1.0) devices to server (www.nevada.net) on the other side by ipsec vpn tun...
The madman who previously supported the client's network had created the following setup.1. The ports of every switch in the network are configured as access vlan 1.2. All subnets are /24. At any switch and at any port I connect client with any of th...
Dear Concern, We need monitor whatever data is exchanged over layer 2 must be logged.Please suggest if, Cisco switches have utility for logging & monitoring local LAN traffic.Hoping this is the right forum and we will find find fruitful outcome very ...
Hi Team, While I was to try configuring Micro BFD using the attached template, I have faced the problem with the BFD commands in the port-channel, could you please help me how to deal with this issue. Bellow is a command: Admin-DC-MW(config-if)#port...
I have a device connected to an access switch port. I would like to configure a net flow to gather the amount of traffic going via the interface. I will be sending all that data to SolarWinds. My question is how do I configure a netflow on WS-C6506. ...
hi,we have an very old hp switch environment and plan to change the whole infrastructure to cisco. We plan to build a parallel environment and switch over after configurating. Therefore i have two test devices. Cisco C9200. My plan is to configure al...
Hi All,Having some query regarding Cisco catalyst switch, it will be very greatful to me of any one help.1) having an Cisco WS-3850-24T switch running firmware version 03.06.06E and I need to load an image 16.09.03a and boot a switch with new image. ...
