Switching

were do we connect the servers to Nexus 7K ? is one of the interview questions  all the servers should be connect to 5k or 3k ,then it should be connect to both the VPC switches . I don't know whether is right or wrong . can anyone help ? thanks 

Hi all I need help, I've got myself into a right pickle with some vpn configurations and I don't how to resolve it. I have 2 physical sites and a connection to Azure. Site A has a 1921 with a Tunnel to Azure which works perfectly, under the 1921 sits...

Hi All, I need help to clarify a doubt. I have searched for any document but couldn't find any. If I connect a switch with no config to a vlan having DHCP server, will the connected switchport by default send any DHCP broadcast automatically and get...

I have a Catalyst 3750 switch at a remote location that hands out DHCP addresses to clients. I need to enable options 66 & 67 for remote-boot capabilities, but I am not sure on the syntax to use. on a windows DHCP server, the setting for 67 is 067 Bo...

Dear Experts, I have a new setup coming up. Core switches:Cisco Nexus 9372 PX's Core1 and Core 2 Distribution switch:Cisco 6509(only one switch) If i have two Nexus 9372PX's in Core and connect downstream to one distribution switch with a /30 conf...

Hey, So been seeing the -E switches appear in our inventory lately and been rolling a few out. Run into an "ohhh can I do that..is it safe...." It dose work i know that much and i saw no issues. So normally- when I say normally I mean I've never be...

Hi all , Need you help . My Scenario is ISA router 192.168.1.1======= L3 SWITCH ==========PC 192.168.2.100 INT VLAN 193 = 192.168.1.254/24 INT VLAN 192 = 192.168.2.254/24 - - router connected to switchport 0/13 mapped with vlan 193 -- PC connected...

Hi, I need to select a catalyst 9300 series with 1/100/G/10G port

Hi ! I've  got following problem within switches in my company, I try to connect to trunk catalyst switch 2950-g but unfortunately I get inconsistent peer vlan message and stp blocks ports on my switch as well as on core one. That leads to some link ...

Since IOS 15.3(3)M the type 8 and type 9 password encryption is supported. However as far as I can find this only is applicable for enable secret passwords and local database password in combination with "username ...." configurations. Is it also pos...

we have two routers, established as ebgp neighbor, now bgp state is active, but both router's connected interface is up, so why it is showing active?

Hello, Installing new Distribution Switches (4500-X in VSS) connecting to 3750-X's stacks with NM-10G cards.  We are going to setup 1 x 10G connection via dark fiber to start with, and will more than likely buy the SFP's (using fiber mux) at a later...

Is it possible to bridge a connection from interface GigabitEthernet 0/0 to GigabitEthernet 0/1 and a EHWIC-4ESG on a 1921 router?