Switching

Hello, Following is my new setup. I have configured L3 Cisco 3560 switch. Connected L2 2960 switch to port 24 of L3 switch 3560 for wired clients via DHCP scope, which is working very well Then Connected AP Cisco 1600 to port 23 of L3 switch 3560 for...

Hello, I'm currently trying to find out if there's a way to use ospf to redistribute the /32 ip address that's assigned to an interface with a /24 address. This would be useful as I have a core router (R1) that has two point-point links that connect ...

ok this is very strange . 50 - 100 switches  i can ping 80% of them fine . 4 or 5 switches  on my network i cant ping from the pc . but if i go directly to the switch i have the computer connected to that is 5 hops away from the other switch and any ...

Hello,  I've configured in my topology (attached below) an IPSec tunnel between the Firewalls which allows PC 1 and PC 3 to communicate with PC 2. The routers R1, R3 and R4 are configured with EIGRP and the Firewall and the remaining routers are con...

Dear Team, Actually we are using cisco 3750 switch in two separate segment, But in first switch we can able to access IP phone using POE port but the same version second switch POE is not working?  Is i need to configure anything to activate the POE...

Hi anyone seen this error? Not able to find info about it.  %EC-SW2-3-INVALID_CHANNEL_GROUP The channel group number 853 is invalid. The valid range is 0-512. This is a channel to which a wism2 blade is connected. As the channel was created by the s...

Hi All,           We are analyzing the configuration change events in Cisco Switch 1941. Could you please provide the sample events for it. Regards, Shalendra

Hi Everyone, I need to upgrade IOS XE on a pair of 4500X's...Id prefer not to try/use ISSU, as they are remote switches and in production(ISSU may work(now ;) ) without issue, but Ive read too many bad reports, so would prefer not to "try" this meth...

friends i have spend my last couple of weeks studying this .. completed a CBT also on QoS but as i am very new need your help in implementing this as this is a production setup. I have a WAN link of 10MB (F0/0) and LAN side i have multiple sub inter...

Hi all, I'm looking for an aggregation switch for approximately 37 access switches all with 10G uplinks. The site have some 6506-E's with older line cards at the moment so we're refreshing this kit. The 6500 10G line cards look to be heavily oversub...

Hi There, I am not sure If I have chosen the correct forum, Appreciate if someone can suggest the correct forum name If this is not the correct one. Here is the summary on the help I need. I have an ASR 920 IOS XE router , now I have not configured a...