Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello, Cisco Community!I’m really happy to share that I’ll be hosting the Cisco Community Lab Series, a brand-new hands-on learning journey designed to help you build practical networking skills step by step.Every Thursday at 8 PM EST, I’ll post a ne...

Resolved! STP Loops

We had a trunk link go down on a switch due to the fiber cord being bent. I replaced the cord and wanted to add a redundant link just in case this happens again. When I added the second fiber to trunk link, a loop occured instantly. Once it was unplu...

bmack2121 by Level 1
  • 901 Views
  • 4 replies
  • 0 Helpful votes

Hello, I require some help/advice. We have a stack of 3750, which is the default gateway for all our Vlans.  The gateway of last resort pointing to our external Firewall is 10.62.0.5     We are in transition to use another firewall from a different v...

After upgrading the IOS on a Cisco Catalyst 3850 and rebooting, the switch gives the following error and can't get out of bootloader mode: Error loading "flash:packages.conf" Interrupt within 5 seconds to abort boot process.Boot process failed... The...

lukecr-01 by Level 1
  • 3504 Views
  • 4 replies
  • 0 Helpful votes

Hi, I have 2 Nexus5000 completed with 2 nexus 2000. I am trying to get a vPC up between both. On the nexus 5000 : Int eth103/1/13 switchport mode trunk switchtrunk trunk native vlan 110 switchport trunk allowed 2,3,4 channel-group 121 mode active ...

I have been banging my head for a couple of hours now trying to get an APC SmartUPS 1500 to take a DHCP reservation.  I have followed the doc here as well as this.  I have tried placing the reservation within its own DHCP pool, as an entry under the ...

Hi we using the following topology 1- 2 x N9396TX vPC 2- 2 x C6800 VSS 3- HP blade system C7000 and virtual connect SW the configuration: we configured the N9300 using vPC and 6800 using VSS hp blade system is virtualized using ESXi 5.5 and we have m...

Amr Hafez by Level 1
  • 657 Views
  • 5 replies
  • 0 Helpful votes

Dear Experts,My switch running is normal but suddenly it has problem with red light(Output fail) as attached file.I also try reboot but seem to switch can notThere is output while switch reboot: ******************************************************...

Hi, We have a campus network where students in their hostels are connected to the network through 2960 switches. On theses switches were have port fast and bpduguard enabled. But since past few days we are observing that a particular users' port is b...

I want to make secondary ip address effective on the happening (say reachability failure using ip sla) of certain condition/event.  e.g. ip sla 1 icmp-echo 123.12.1.1exitip sla schedule 1 life forever start-time now!track 1 ip sla 1 reachability !int...