Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

I received a new Catalyst 3560-CX Series switch.  I attempted to upgrade the switch by copying a new image from a USB flash drive directly onto the switch.  A successful process that I've done with 2960X series switches.  The process failed and now t...

Hi all,    I need help,  we are using Cisco catalyst 2960 switch for our location,  in switch for security purpose we are using Mac access list and all devices of location getting the ip thru dhcp which is configure in switch,  now I want block dhcp ...

Not use to these small business switches. They speak a little different language. Trying to isolate a vlan to just allow internet access but not LAN access. Involves two sg300 10 ports and a 5505 with full security license. Unable to pass traffic to ...

Hi!It seems I have seen this before (and even done it once a few years ago).. but it has been a while.I have a stack with a Cisco 3750 stack that I have to replace a member.The replacement switch is a 3750X. I think I have to upgrade the IOS of the o...

My cisco 2811 compact flash card went out and I bought a new one. And my router is stuck in rommon and I can not format compact flash. And some one said to format on the PC and then I need to copy the system file from a working compact flash disk.

Good day all I Have been tasked to configure a new Nexus 93128TX to replace a pair of Stacked 3750's. I have never used the new NXOS and am still a intermediate level Switching and Routing guy. So Of course If I could get someone to do it for me and ...

Dear AllI have 2 Nexus SW 7706 with 1 SUP-2E in each SWIf I configured VPC between both SWs If SUP in one of them go down does the performance affected ?as I knew that VPC make both SWs individual in management but appear as one SW to down stream dev...

Amr Hafez by Level 1
  • 1739 Views
  • 6 replies
  • 0 Helpful votes

  Folks -The setup is simple.I have 2 Dell switches connected in a VLT, like Cisco's VPC.Dual-homed to the Dell switches is a Cisco L3 switch using a split LAG - Po1. The Cisco connects to Te0/6 on each Dell switch.Each Dell switch has an SVI for VLA...

visitor68 by Level 5
  • 2946 Views
  • 4 replies
  • 0 Helpful votes

Hi all,We have a pair of 4500X switches running in VSS mode. They are running Version 03.04.06.SG RELEASE SOFTWARE (fc1).Suddenly, the secondary unit crashed and started rebooting in a loop, as showed below. I would like to know if there is a way to ...

Hi, I have a 2960 which has been stable for several months. The switch crashed and then automatically reloaded without loading the saved configuration in flash. We reloaded the switch manually and the switch booted as expected with the correct config...