Discuss Catalyst brand switches with peers and experts.
Showing results for 
Search instead for 
Did you mean: 


Forum Posts

Good afternoon gentlemen Even searching some articles regarding MLS configuration and CEF configuration, both concepts are still not clear for me.We have a 6509E switch with supervisor 720, with submodules PFC3B and MSFC3. IOS is 12.2(33)SXJ7.Sometim...

Hi,I planning to stack two switches together with FlexStack and configuring a cross stack etherchannel; does this configuration require a special configuration or I have just to configure the ports as usual (I mean with channel-group ... mode ... com...

e.ciollaro by Enthusiast
  • 2 replies
  • 0 Helpful votes

Our C3705 has 4 VLANs configured on it.  The subnet for VLAN1 is 192.168.1.x and I'm connected to a port on this switch on that VLAN.  My connection goes from the switchport, to patch panel, to dataport on wall.  From there I've ran another patch cab...

rlamadori by Beginner
  • 2 replies
  • 0 Helpful votes

Hi AllIm looking at purchasing 2 4507 switches to run VSSShould I be looking at the Sup-8 or Sup-7I see the 8 has wireless functionality, however I will not be using this, Its for a collapsed core deployment with about 2500 devices on site. cheers  

we set the following config and version.---------------------------------------------------------------------------------------interface FastEthernet0/1 no switchport bandwidth 5000 ip address!interface FastEthernet0/2 no s...

Hiiii ,im trying to block traffic of skype by cisco NBAR , i have cisco router 1941with ios :System image file is "flash0:c1900-universalk9-mz.SPA.152-4.M5.bin" im trying to match skype traffic by "match protocol skype" but it dont match !!!i googled...

Dr.X by Explorer
  • 1 replies
  • 0 Helpful votes

 I have an device that use Multicast and is unable to aquire an ip address when connected to a 2960 switch. I have a 3560 switch that is configured with the DHCP scope. We have DHCP pool configured. layer 2, and layer 3 switch's. Basically what’s hap...

anilcisco by Beginner
  • 13 replies
  • 0 Helpful votes

I was wondering if anyone has any experience with running Macs' on their Cisco networking equipment. It seems to only be one generation of IMacs' that disable ports on our switches. I do realize many variables may have a role in disabling port sett...

Hi Guys,We have recently deployed the above model line cards to replace our old WS-X4248-RJ45V cards.Now we are facing a strange issue, whereby some ports/phones work on the new cards and others don't. However all phones work on the old cards.All the...

Trying to implement wccp on a 3750G-12 stack with Websense Security Gateway Appliancefor multiple vlans. Need to know what level does the 3750 support for wccp. I have attached a sample of the wccp commands I have configured.

gbarden by Beginner
  • 3 replies
  • 0 Helpful votes