Switching

Nexus 7010 - How do you kill Non-Running processes?

Everyone, I prematurely quit the the "sh install all impact kickstart n7000-s1-kickstart.5.2.9a.bin system n7000-s1-dk9.5.2.9a.bin" command (Ctrl-C) and when I run it again, I receive the message back "Another install procedure may be in progress. Pl...

4500 High Cpu / K2CpuMan Review / Host Learning

Hello,there`s a 4500 Switch with High Cpu Load: #show proc cpu sorted | ex 0.0CPU utilization for five seconds: 88%/3%; one minute: 92%; five minutes: 93% PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process 41 1147238344 45841172...

WS-c2960xr--48ts-i support wccp?

Hi Everyone!I want to know if someone knows if the WS-c2960xr--48ts-i support wccp. Thanks in advanced.Regards.

channel-group mode for VSS MEC link to WLC

HelloI have a Cisco 5508 WLC with LAG enabled - this LAG connects to a single VSS chassis (VSS etherchannel mode is "on" as per the WLC documentation)I'm looking to spread this LAG across both the VSS chassis - Cisco's VSS best practice document belo...

spanning tree

If you have a port in the BLK state that should be in the forwarding state, how would you ensure the issue is spanning tree and how would you correct?

Resolved! Hardware End-of-Live

Hi there,I need to know the end-of-live for a 3750-X. Sorry but I didn't get how to find the exactly information about it, so I ask does Cisco to announce something our it depends of the date that I bought ?Best regards,Ederson

Resolved! HSRP- How to monitoring Interfaces

Hi,I still learning and I have a few questions,I'm trying to prepare the infrastructure:2x Router – 29112x Switch – 2960GI configured HSRP, router R1 is active and R2 is the standby.Everything works and and when I do shoutdown interface Gi0 / 1 on ro...

Resolved! Will two pairs of L3 switch in HSRP creat a loop?

So, I have two pairs of L3 switch in separate HSRP configuration. Those two sets are connected by only two connections, Primary of each is connected to primary of the other only and the standby is connected to a standby of the other. The connection b...

4500-E series .. is it nearing end of life?

Is there a way to find out when Cisco may be planning to obsolete the 4500-E series switches? Or alternately, is there a way to get assurance from Cisco that they aren't planning to make it end of life for X number of years yet?It concerns me to see ...

LAN network design - Core/access with Cisco 6513

Hi,I have been tasked with setting up a new branch office, with 100+ users, a stack of servers (1Gb-based) and some wireless access points, WAN block (ASA 5520 and a couple of routers.)At the moment, port requirement is around 400. As there's not eno...

Resolved! Reload Command Unexpected Results (Bug?)

As others probably do, when making a possible service affecting change I have used the "Reload in X" command to reboot the router in the event the change I am making blocks my access to the device. I wanted to share an unfortunate experience I had r...