Switching

For WiFi traffic from source to destination MTU size should ping up to 1472 Now the MTU is pinging up to 1468 because port level MTU size is 1500 we need to increase 1522. while we changing size it will impact my traffic ?Model number: WS-C3550-24-DC...

Hi team,I bought a cisco 1941 router from first own of this router. And he did transfer ownership from cisco license webpage. As I use for study purpose. Now I don't want to use anymore, and sell to another company to use. Can you point to how can I ...

I am trying to get an AT&T 3G MicroCell (made by Cisco) to communicate to the Internet through our Cisco 1841 Router. The router has only basic NAT  and no Firewall setting.The AT&T 3G MicroCell is not a configurable device and it directly connected ...

Hi,  I have several Cisco 2960 switches. I'm pretty sure the data sheet says it only has 2 gigabit uplinks.  However, I see 4 uplink ports (2 are copper and 2 are fiber) and I see 4 gigabit interfaces in the switch config.   I would like to use 3 of ...

Hey guys I am simply trying to get inter vlan routing working on an SG500X operating in standalone mode.I have setup a couple of vlan interfaces on the switch which I assume are routed automatically when ip routing is enabled.I can ping these vlan in...

Below is the current ACL    10 permit 192.168.56.49 log    20 permit 192.168.56.50 log    30 permit 192.168.56.51 log    40 permit 172.16.30.47 log    50 deny   any logIf I try to change the numbering of the ACL so 172.16.30.47 is second in the list ...

 Hi all,We are facing some issues in Nexus 7K.when we excute the clear mac address command,it is going to be restarted.Could you please suggest me what might be the reason ?Thanks & Best regards,Krishna Chintada

ssue:======Replaced the faulty switch with the new one after which I see the port was shown down.europe3750#sh switch detailSwitch/Stack Mac Address : bbde.4B9H.5690                                           H/W   CurrentSwitch#  Role   Mac Address  ...

Helloo Guys, I want to configure cisco router 3645 for dual provider,1> Router is configured on Lease Line for Intranet ( Internal application access ) and internet both from HQ.Now we are going to hire ISP line locally from local ISP for internet us...

I have a few questions that I need help with. 1) If using a  7940 phone, it sets the CoS bit only (?) to 5, correct?  It doesn't actually set a dscp value too, correct? 2) The switch maps the cos to dscp values internally using the map table, correct...

I have one server connected to distrubted switch or acces switch  in network .They were 45 switches in netwrok and need help how to find that server  connected switch  from  Core switch ?How many  mehtodes and process we can use to find that connecte...

hi allour topology is that, core is 6500 which one port set vlan and directly use one 1G utp cable (only one cable)connect to 2960s-48T on each floor.there are one 2960S-48T and four 2960-24T  on each floor.how to connect the switches ?a. one to onen...

I have a 5010 that simply won't load any system image.  Loads the kickstart image just fine, but once at the Switch(boot)# prompt just give me garbage when I enter "load bootflash:n5000-uk9.5.1.3.N2.1b.binRestarting system.Loader Version pr-1.3loader...