Switching

I have setup IPSec VPN between RV220W (FW 1.0.5.8) and RV180 (FW 1.3.0.10), public addresses are used on both sites, RV220W subnet is 192.168.2.0/24 (subnet A), RV180 subnet is 192.168.3.0/24 (subnet B). No radius and additional settings are made. Th...

Hello.  I have 4 Cisco 2960-X switches configured with stack cables.  Then one 2960-X in another computer room that is trunked in to the stack.  How do I configure dynamic ARP inspection in a stack config?  Every config example I find explains how to...

 Hi all  As in the picture vlan 13 has priority 200 sw2. if i run traceroutei can see the traffic hits at sw2 ( interface 192.168.7.10) If that is the case , i need to change the access list only on the SW2. ( because traffic never going to the SW1) ...

A client has requested an B2B vpn with our company.  I decided to use RV042 dual wan router on our end.Our client wants us to use non-RFC 1918 IP address because they cannot route to RFC 1918 addresses for interesting traffic.In our private network, ...

Hello All,I'm working in a BGP prefix list configuration and i'm seeing a strange issue. Issue: As per the cofiguration we have defined the prefix list to filter the incomming subnets. Though a specific subnet is not allowed in the prefix list but th...

One of the standby ip cannot ping or access  hsrp standby ip cannot ping interface Vlan22 ip address 192.168.12.2 255.255.255.0 standby 0 ip 192.168.12.1 standby 0 priority 200 standby 0 preemptendinterface Vlan22 ip address 192.168.12.3 255.255.255....

Hi,We are about to install a new network consisting of Cat 4500s with Sup7E at the Access Layer, with Nexus 7000 at the Distribution and Core layers. We have 14 floors with at least three 4500s on each floor. Within the office block where the Access ...

  While trying to debug why logs from my 6509-E are not going to the Linux server syslog directly connected to the switch. I tried to ping the server in EXEC mode on the switch but it failed??? I tried the same thing on my 2 3750's in a stackwise con...

Hi All, My Question is Does Cisco Switch SG500- 52 can support to creates Vlans in this switch.

We recently changed out routers at a location - our secure SSID is working as it should however our Guest SSID is not broadcasting. The DHCP server is at 10.27.129.31 which serves up the IP's. Nothing has changed on the AP's(they were not upgraded or...

hi,noticed this on sh loggs:153255: Oct 16 22:10:00.020 MNL: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet3/0/37, changed state to down153256: Oct 16 22:10:00.020 MNL: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet3/0/41,...

hello all,I have the following design for a site: Provider delivers channel with HSRP redundant routers, but access level in not redundant and represented by one switch.Am I correct that there is no way no provide redundancy on access level only with...