Switching

Is there a copper 10Gbps SFP for the Catalyst 2960-S that is compatible for connecting to a 10GBase-T module on a Catalyst 4900M?I know there is some copper SFP's, but I don't know if they are 10GBase-T compatible. Also, with the limited distances, I...

Hi, OK, this is the best forum I could find for this one. Is it possible to team a 10GBASE-T RJ56 port and a 10GbE SFP+ (fiber or twin-ax)? Does the physics (e.g. mixing fiber and copper) prevent it? Thanks,cisco_reader.

Is there any issue with Catalyst 6500 and the new X2 10GBASE-T connectors inside a WS-X6716-10GE module where the connector is not recognized by the sho interface status command? The switch is running IOS 12.2(33)SXH8b.The connector is unkown as show...

I have a Cisco 3600 Router in front of our network and we will be moving a few websites to a new server.I'd like to add a few rules to the 3600 to redirect all traffic from one  of our ip address to the ip address of the new servercan this be done?If...

Hello, I have a particular problem: on a router with one in and one out interface, i want to route all traffic, but i want to bridge one specific well-known MAC address. I wonder if this is possible. On a cisco router, I can do IRB, but each interfac...

I have configured a Vlan , trunked a ports but I can't ping the pc. the file is attached below. guys help me out.

Hi All, need help with nat setup, so my setup is as follows (just on packet tracer), i have 4 routers which can be seen below , R1, R2, R3 and the Gateway 1.1.1.1 which is supposed to be my isp. so will refer to it as ISP.If i ignore R2, and concentr...

I have topology like :Core 3560x ---------------------- Baseline Switch Manage 2924 ------------------ Switch Unmanage ------------------ AP ------------------ Client (A) (B) Vlan 2 = 192.168.2.x/24Vlan 3 = 192.168.3.x/24 If client A have ip address ...

Hello I am looking at a 1Mbps link and there is a switch connected at the end. There is a PC connected on one switch port and the max traffic it can get for a file download is 40Kbps on that port. there are no other PCs connected to the link and no Q...

Hi All, I am posting this issue on the Cisco community site, I've also posted it in the J-net discussion forums. I have three Netscreen-25 firewalls on my LAN. Two are configured as a NSRP pair/cluster and the thrid is a standalone firewall. All fire...

Hi guys, i wanted to activate auto-qos on my LAN, but when i get to the C4500 i find that the command auto .... is not accepted  Sh Version :Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500e-UNIVERSALK9-M), Version 03.05...