Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Dear All,I am azad Ali i would like to change my track to cisco, Currently I am working in saudi arabia as an Exchange Server Admin.we have 3 sites it is all of the connected with leased line,each sites are connected with router and one distributed s...

Hi all,I have attaced a set up i was doing on packet tracer. I have everything sucessfully up and running. However i do not understand one thing. I have set the default gateways of each PC to be their respective VLAN interface on the Layer 3 switch. ...

Resolved! Route-Map Question

Hello please I have 2 CacheServer in my Network , and 2 Range of IPs , i want to route the first range to CacheServer1 and Second range to the CacheServer 2 , can i make 2 Route-Map for both of them , find the configuraition bellow if its true or not...

Hi,I am doing a lab test to verify QOS on a Cisco 2960s 49P switch. The service policy applied to the interface Gi1/0/1 seems to be working as Wireshark capture (on the uplink trunk ports) indicate all traffic is correctly marked ("ef" for testint pu...

rick505d3 by Level 1
  • 3065 Views
  • 2 replies
  • 0 Helpful votes

hi,i have a C1760, and upgraded it to max specs.but the device doenst seem to hold the configuration i give it.does anyone have an idea what could be wrong with it?This is the start-up >Sep 13 13:45:07.698: %SYS-5-RELOAD: Reload requested by console....

For some reason I am unable to get o fut to the internet with my laptop. From the 2821 I can ping out just fine. I enabled DHCP on the 3550 and am able to pull a proper ip address. I also can ping the default gateway and router from my laptop but not...

shimabuku by Level 1
  • 1367 Views
  • 8 replies
  • 0 Helpful votes

Dear Members, I have one 1841 router and it giving my following message:Queued messages:*Aug 31 10:26:03.359: %SYS-3-LOGGER_FLUSHING: System pausing to ensure console debugging output.*Aug 31 10:26:03.291: %SMC-2-BAD_ID_HW: Failed Identification Test...

I just installed a new cisco 2921 router on a remote MPLS location.  I applied an acl to the wan port of the 2921 and I am not getting any "hit counts" on the acl even though the last statement on the acl is "any any".  Is there something I need to a...

Review Cisco Networking for a $25 gift card