Buy or Renew
Buy or Renew

Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Labels

Forum Posts

Start a conversation

Config SSH on 891W ISR?

I believe I have the steps done at the IOS to config the WAN port for SSH, but I still can't connect to it.  I have "logging console 7" on so I am able to see that the router is dropping my TCP session requests.  I figure this is just the built-in zo...

cluovpemb by • Level 1
  • 3103 Views
  • 11 replies
  • 0 Helpful votes

Resolved! dhcp snooping

On our network , an edge switch which is in a stacked mode has been configured with below on two ports,interface fa0/5switchport trunk encapsulation dot1q switchport trunk allowed vlan 11,21,5switchport mode trunk storm-control broadcast level 15.00 ...

suthomas1 by • Level 6
  • 1101 Views
  • 1 replies
  • 0 Helpful votes

Resolved! SUP2T QOS channel consistency

Hi allI have a catalyst 6506E (WS-C6506-E) with a SUP2T supervisor (VS-S2T-10G) card and a 10G interface card (WS-X6816-10G-2T) + DFC4.I have configured an etherchannel to another switch with the 2 10Giga ports of the SUP2T card and 2 10giga ports of...

cminard by • Level 1
  • 3879 Views
  • 2 replies
  • 0 Helpful votes

Routing issues between sites A & B via MPLS

Hi All,Hope you can help with this one or certainly point me in the right direction.We have two MPLS circuits managed by two different suppliers, one carries VOICE the other DATAWe are to decommision the VOICE MPLS and have increased the bandwith of ...

QoS on wireless network

Hi, Let's talk about QoS on wireless network.I am not sure how to proper deploy a QoS in wireless network.Based on Cisco documents. looks it create several SSIDs and seperate clients by SSID.How to do it? we may mixed high priority and low priority a...

Resolved! PCEX-3G-CDMA-V Question

I understand that the PCEX-3G-HSPA requires and a sim card. I also have a PCEX-3G-CDMA-V. Does this require a sim card as well? And if so, where is  the sim card installed?Thanks, Pat  

Resolved! IS 4507R FAN Tray hot swappable?

HiWe have a Cisco 4507R switch with sup V. This switch fan tray has partial problem .No light in fan tray. We got another fan tray. Can any one tells me is it hot swappable?What procedure should I flow without any interruption our live network?Would ...

aminulnt by • Level 1
  • 5662 Views
  • 4 replies
  • 0 Helpful votes

ios issue with vlan update

Hi, I am trying to change the default IP address in vlan 1 on a cisco 861 but everything I do so my connection via SSH hangs and all ssh/telnet attempts are refused.my commands are as followed:int vlan 1ip address 192.168.1.1 255.255.255.0[hangs]my c...

1712 High Processor Utilization

Hello,I am running a 1712 12.4(25d) with NAT, VPN and FW/IDS.  I have a broadband ethernet connection at 20mb.  As I run some traffic through it, the processor jumps up to near 100% and throughput comes to a screeching halt.  IP CEF is turned on and ...

m-sherman by • Level 1
  • 992 Views
  • 3 replies
  • 0 Helpful votes

Resolved! OSPF areas

Hello Everyone,Please see attached file. When I issue the command"show ip route ospf", it gave me nothing. How areas affect OSPF enabled routers? I already configured this in one area and it works fine, but why is that if I configure multiple areas o...

Load more