Switching

Thanks in advance for your inputs.This is the scenarioCustomerNetwork       ---------PE1-------MPLS cloud--------PE2----172.16.4.0/24172.16.10.0/24- PE1 and PE2 have a BGP vnpnv4 session between themA router in the MPLS cloud needs to reach the 172.1...

Hello,I have a 4503 switch, two 3560 and a couple of 2960.I've created a L3 route between the 4503 and the first 3560. I've linked the first 3560 and a 2960 with a L2 link and then link this 2960 to the second 3560 with a L2 link.Now, I want to add a...

Hi,In order to support multicast for Unified communication for cluster establishment of Linux based servers, we have been advised to run following commands. /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-...

HelloIs it possible to configure an ACL on an interface of the Catalyst 2960G switches to filter network-traffic against IP-adresses and port-numbers?I 'd like to restrict the traffic for one station.RegardsPascal

Hi Guys,Strange one, i have configured a secondary subnet on a dot1q subinterface to allow for expansion. I created a secondary ip address on both interfaces, then configured another standby group for this subnet, something like this:R1:interface Gig...

I configured all our Links with ip pim sparse-modeI also configured static RP on one router.Must this RP be konfigured on all MC-routers in between Source and receiver or is it sufficent to configure it on the leaf-routers , where sources and receive...

I have configured Port security in 3560 switch it is working fine only the issue I am facing is  once I change IP address of that Host the switch Port go shutdownsince I have configured port security I believe I am changing the IP Address not the hos...

Hello,I have a question about IP translation. Suppose that I have 6 machines and each machine have about twenty touch panels (Proface) which have assigned IP adress. Unfortunately (made by manufacturer) on each line touch panels have the same IP adre...

hi all,i have a lease line with an ISP on a branch office and it always gets congested due to high downloading stuff. i thinking of setting QoS on this link. can anyone advise what is the minimum discouraging data file size (or policed) that should b...

Hi allIf I want to restore a backed up config to my cisco WLC 4404 how would I do this if the controller has been reset to factory defaults. what is the easiest way?cheersCarl

Hi everybody.Its possible that we can have 2 DHCP Servers in a single network? how is the method to avoid conflicts? when the leased time expires could be any kind of problem? how can I avoid it?I found the following error in a LAN switch in our netw...