Switching

Hi,I have this design issue for a Cisco 7604 platform with PFC QOS where I have ingress tunnel in tunnel traffic on a interface which I have to  mark with qos-group value. In PFC any incoming DSCP is mapped to the COS table and treated accordingly on...

I'm designing a solution for a large apartment complex that is providing free internet services to their tennants.  The complex is devided into three areas.  Area C, as an example, comprises of seven buildings with 72 units total.  I would like to is...

We have 2 CISCO 2951 routers and 1 ASA 5510 firewall. We have 2 internet links from different service providers (Leased Lines).How we need to configure both the routers for load balance and failover?

Thanks in advance for your thoughts on how I tackle this issue.  I have 2 vlans with an 877 providing the routing and a DSL for Internet access.  I have a device on Vlan 2 which I can ping from Vlan 1 so routing is working and devices are setup corre...

Is it possible to shape traffic on multiple sub-interfaces on an egress port of an IOS router? I have a situation where I will have several virtual circuits from multiple spoke sites terminating at an HQ site which will be the hub, presented on a 100...

Hi, I have a C6009 with two WS-X6K-SUP1A-2GE supervisors with CatOS and MSFC2. I would like to know if this supervisor supports 10 Gigabit cards or modules?Does it support iSCSI and Jumbo Frames?Any recommendation?Thanks

Im trying to define ACL's for use in policy based routingproblem is i need to specify 2 ACLs,one that puts traffic from 10.5.0.1 to 10.5.0.6 destination 172.17.0.0/24 through hop 10.4.0.1and another that puts 10.5.0.7 to 10.5.0.12 destination 172.17....

Is egress bandwidth limiting on a 3750E limited to a physical interface? I.e. is it possible to limit bandwidth per vlan on a tagged interface?

Dear expertsI have several AP´s working with WLC 4400 series. The workstation with Cisco PCI wifi cards detect high latency when I ping several servers. It´s strange because always is the same patrol of high latency. Each 20 sec 3 peaks of high laten...

is it possible to change mpls exeperimental bitfor traffic that enters a 7600 interface ?i've tried with  "no mls qos mpls trust experimental"configured under the input interfacebut my attempt was unsuccessful

Tryin to set up a new network in the current LAN..using secondary IP address..currently using glbpso 172.20.255.17 would be the GW of the device in it.From the WAN i can hit the gw ip addres and the real ip address on g0/0...but from the directly con...