Switching

Hi,Do you guys also experience this? We are having HSRP flaps everday and we don't know the cause. Our core is a 4506 switch running Supervisor Engine IV and the trunk of the two core switches is port-channel using Gi1/1 and Gi1/2. The HSRP timers we...

Dear all,In the cat6509 switch with dual sup1A and MSFC2,the standby supervisor engine is in ROMmon mode. Following is my findingrom> dir bootflash:here no file found.then I did the ymodem download the boot image thro hyper terminal.Within 2 minutes,...

Hi all, The output of command SHOW PROCESS CPU on Nexus 7000 is too simple. I have no way of knowing about anything more detailed, such as interrupt level cpu utilization.Is there any way to get some detail of CPU utilization on Nexus 7000? thanksWan...

Hi all,I like to find the standby supervisor engine serial number on 6500 with sup 720 chassis.I tried sh module sh idprom I can not find standby sup but all other modules and primary sup 720 details.How can i find the serial number of standby one.Pl...

Hello all.Please help my.Dont save ip policy route-map.IOS on catalyst 3650 is c3560-ipservicesk9-mz.122-52.SE.binSwitch(config)#route-map test-access permit 10Switch(config-route-map)#match ip route-source 20Switch(config-route-map)#set ip default n...

We are deploying qos configurations for access servers c3560-E switches. We want to know differences between these kind of configs:Interface GigabitEthernet 0/1 mls qos trust dscporpolicy-map trustDSCP class class-default trust dscpinterface Gigabit...

Hello.I have to connect two sites(I have connected them and everything works OK).The problem is that I do not want that broadcasts come from one site to another.So I have created another vlan on HQ and Remote SWITCH. I have set the port to witch the ...

(this is for administration purposes)Should I connect the ethernet port of the 2950 switch to the console port of the other switches/routers or will this not work? Or is it that I can only connect ethernet ports to other ethernet ports....Because I w...

Hi,We have 1841 router used as our Data Link router. It has 2 interfaces, one with connection from ISP and other for our local network.We have 2 nos 3750G stackable switches in our stock. Is it possible that we can replace the router with these switc...

How to monitor Cisco 6500 Native IOS Sw 12.2(18)SXF7 backplane that has all virtual etherchannels for almost each module like CSM, FWSM, WiSM,IDSM etc.

I have already tried rebooting it and updating to the latest ios (12.2(52)SE - IP-BASE) but I still have access to only the first 8 ports. I have 16 servers connected to these dead ports (all running at 1000 in Auto mode). At least 24 of these dead p...