Switching

Hi allAm i right in saying flash is where the files are stored, IOS, and boot loader etc ? and ram is what they load into once the router has booted, what is the ram also used for? when would I need to upgrade the RAM ?

I have to get some multicast traffic across a non multicast network, and have had a suggestion I use DVMRP tunnels. The site routers are 3750, so no GRE,.Try as I might, I don't seem to get it working - I don't think the tunnel it establishing proper...

Hi,Is it possible to make a Router as an NTP Server. My requirement is to allow Windows Domain controller to connect to NTP Server to synchronise the time and then all other server will point to Domain Controller.Looking for a best options

Hi,Just a little advice about the setup I am looking at. I have an edge router 2651XM with a WIC-ADSL card in. I have a PIX 501 and and a Catalyst 2940. Is it possible and a reasonable idea to host a DMZ using a a couple of dedicated ports on the swi...

Hello,Recently bought a used 6509 with a Sup-720, it came with a compact flash and seems like the version on it is:12.2(18)SXF8 (advanced enterprise services)Now on cisco's website, it shows like a SAFE HARBOR but when clicking on safe harbor but whe...

I'm working on our co-location setup and I'm getting ready to make some upgrades and I'm not quite sure what the best solution is. Here is what I have now:- a block of 32 IPs from provider- one firewall in front of all of my devices- one unmanaged sw...

HSRP - Does the Standard Multilayer Image provide a routing protocol that can converge as rapid or near rapid (10/20ms) as when using EIGRP and HSRP together...Basically, is the Enhanced Mutilayer Image the best choice for achieving the fastest fault...

Hello,I found a mac-address on my router and after some research, I found tha was generate by ma Cisco 4948. (00:1A:5D) But if I look for the manufacturer, I found this:Mobinnova Corp.I have no material from this manufacturer.Is it possible that some...

I have a Cat6506 running CatOS with Sup720. The supervisory modules keeps on rebooting (see attachment). How can I break out of this? Thanks in advance.

Hi,i am about to have an ip renumbering on our network, what are the things that i need to consider when reconfiguring the vmps

i have a cisco 4500 switch......and the 4th line card on it has all the IP phones connected to it.there r primarily 2 VLANs....109 is for data and 145 is for voice.now i have an other switch(linksys).....which i want to use it for IP phones. I need t...

We have 2 separate networks, each with a different domain. Each network's domain controllers and servers are in the same physical location. Each network/domain has its own router and public address. If I connect a port on a switch on one of the ne...

Hi Everyone,We having major network connectivity problems. I'm going to open a case with TAC but thought I would post here first.I'm seeing a VERY high received broadcast count on 2 our our Cisco 3020 switches. Just wondering if this is normal. Th...

I have a 4507 that's cpu usage is increasing by about 3% on a daily basis.I want to set up a span session for the CPU traffic, but I'm concerned that this might add to the problem.The CPU is currently running at 60%. Any advice would be appreciated.T...

I have a 4506 running IPBASE IOS 12.2(25)SG1. It supports a high-performance computing research area with about 20 servers that get repurposed and rebuilt every so often. Each server has a built-in NIC with two gig Ethernet ports (Penguin Computing...