Switching

I have Supervisor 5 on my 4510. I tried upgrading to the newest version and it wouldn't take the IOS. Could someone explain to me the difference in the 4000 and 4500 images? There are two choices when downloading the images.

I have a router with multiple interfaces aggregating about 25Mb of traffic with a somewhat high CPU utilization. Ping times to the device fluctuate between 3ms and 180ms depending on the CPU load. We have WCCP directing traffic to a Barracuda web f...

All,Can I use ISSU for 6509 software upgrade? Or ISSU is just for software patch?Thanks,

Hi All,What does mean by invalid boot string, how can i set the correct boot string.6513-01#show diagnostic sanityPinging default gateway 192.168.30.1Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 192.168.30.1, timeout is 2 seconds:!...

Hi,I have some 10 servers which is runing multicast applications. Now I would like know those Multicast IP address of those servers.Is there any command to check the same in router.Regardssateesh

Hello,We run a dedicated server business. \We assign ONE VLAN per customer with a 8 IP subnet (5 Usable) for the primary IP of the server + 4 IP's the customer can use.When assigning additional IP's to our dedicated server customers... which one of t...

I have two 6509 switch connected via a fiber trunk on the SUP blade.All vlans are trunked on this trunk.Both switches have monitor sessions set up on them and I am getting an error trying to create an additional one.I am thinking I can remove one of ...

A vendor has requested that I enable multicasting. The video will be broadcasted over a flat network/one subnet. Network consist of a meto-e terminated in a 4503 with 12 2960s. As long as they are sending the multicast traffic to 224.0.0.1, will i...

Hi, I just upgraded the IOS on dual Sup720's in a 6509 chassis. I FTP'd the new IOS on both fine, updated the Boot system to load the new IOS. Reloaded switch and all seemed to work ok.However, every time I do a wr mem I get the following error mes...

Hi All,We are in the process of upgrading our network infrastructure. We are planning to invest on 2X 6500 core switches, so I thought of proposing VSS to the management as the best solution. I have few questions that need to be clarified before that...

I deleted the IOS on a 3750, now I need to use xcopy to reinstall a IOS. I will be loading c3750-ipservicesk9-mz.122-35.SE5.binWhen I put in the following command:switch: copy xmodem: flash:c3750-ipservicesk9-mz.122-35.SE5.binI get the following res...

Hi all, if I have 2 routers, 1 pri and the other secondary, if the primary fails and r2 becomes active, if the primary comes back, will it not fail back to the primary unless I use the preempt keyword? do I need to configure this on both or only 1 ro...