Switching

hi, We have a new ME-3400-24TS-A Switch.Its a 24 10/100 Mbps switch.But when we connect the two PCs on its any of the two ports ,they are not pinging to each other.Both the PCs are in the same Network. basic switching is not happening.Kindly help m...

Hi, on a layer-2 switch , if i enter ip defualt-gateway <ip address> , this defualt-gateway will route which traffic, user traffic or management traffic ?regardsNeo

Hello everyone , i aour company we have configured the squid Proxy server now to end the project i need to cahnge the setting in the router so that people who brouse through the net they should browse through the Proxy Server ....So please help by le...

We are transitioning branch offices (bo) into to an ISP managed MPLS network. The bo will access the Internet through the headquarter's Internet access. Is there a way to configure a PIX to give DHCP IP addresses to the local hosts? Ideally the MPL...

Hello,My core switch (6506) is pegging me with warnings like this one: Oct 27 23:51:29 sw2-int.XX.XX 5882: %CDP-4-NATIVE_VLAN_MISMATCH: Native VLAN mismatch discovered on FastEthernet0/1 (1), with SCAxxxxx(YYY-ZZ) 7/41 (81). - which I am aware of, an...

I'm having a problem with one of our 6509s, the CPU on it constantly goes up to close to 100% for a minute and then drops back down to single digits (it happens every few minutes), it's not causing connectivity issues yet, but I'm worried that it eve...

I need a cale part number thats connected to a port adapter PA-4E1G-120 having G.703 conector at one end and the other end having UTP RJ-45. The length of the cable should be 8 mitres.I found the cable as CAB-E1-RJ45(=). But unable to find the price ...

Can anyone explain what's going on with the switch when it displays this message for any given command entered:switch#conf tCommand authorization failed.Thanks in advance./rls

Hi,I copied a configuration with tftp on switch 2960.In each interface, the commande "dot1x pae authenticator" dosen't copied. I precese that in some switch my command has succeed and other don't succeed.thank you for helpThank you fpr help

All, I need help here. I have 3 Cisco 3750's in a triangle configuration, with one switch at each point of my triangle. There are 2 fiber lines that connect each switch. 1 for normal communications, and the other for a backup purpose. I have about 9 ...

The layout for this problem is:At location #1 there are 4 switches A, B, C and D connected to each other in a small mesh.At location #2 there also are 4 switches E, F, G and H connected to each other in a small mesh.There are several vlans trunked be...

Hello recently I connected my G0/1 (3524) to my Pri msfc. When I connected it to the Pri msfc theswitch failed over to the Sec msfc then failed back, hsrp went into a state change. Is that normal? I looked into it and it only happened for a split ...

I want to check due to which traffic or which source to destination my E1 goes high cpu utilizied.