Switching

Hi,I am trying to access my 1841 router thru web browser. But it is going to below link and giving "The page cannot be found" error. What can be the problem?https://A.B.C.D/archive/flash:home/html/home_aux.shtmlI have enabled:ip http serverip http au...

Hi there. I'm trying to figure out how to setup a situation where we have two different internet providers, that provide two different SLA's for availability, uptime, etc. We want to provide access via the primary internet link to our premium custom...

Hi all, I dont know if anyone on here can help, we are having issues with cisco vpn client remote access, it seems people can connect to the asa using ipsec vpn client, but they cannot get to anywhere, I can see they have been assigned a dynamic acl ...

Good Day,I have two 6509 switches running Sup2 and CatOS with virtually the same configuration. Until recently they were connected to a 2950 (trunking 3 vlans) at 100mbs using media converters on both ends of a fiber run.To get rid of the converters ...

Here is the scenario.A 6509 at the core. Running layer 3. It uplinks (layer 2) to a switch (owned by the state which i believe is layer 3) and routes out to the external network/internet.All other switches in this school are layer 2. Multicast DOES N...

Hi everyoneI am using NBAR on my 7206VXR box to mark RTP stream to DSCP EF and SIP to CS3. Marking of SIP to CS3 works fine, but I got problem with RTP marking. Sometimes output packet are NOT marked, altough the output of policy-map applied on the i...

can someone helpi have just setup a small home network to practice bgp routereflectors and have hit on a snag i have set it up with 2 as's as100 and as200 what i am trying todo is to get a route residing in as100 into the routing table of a route ref...

What is the difference between a IPB Image and an IPS Image? Iv looked all over your site and I cannot find any information.Thanks in Advance

I am looking into access switches for our current network. I am looking for a switch that has the ability to upgrade to fiber if needed. I see that the 2960g has 4 dual purpose uplinks, but I do not see the gbic card prices. How much are the gbic car...

Hi all, I have seen the terms on other switches such as Nortel, saying vlan tagging enable yes/no and then another option underneath saying PVID tagging enable yes/noare these not the same thing ?

Hello Experts,I have an issue in my network where I see almost daily the following error message in one of my CORE switches:Mar 6 11:15:38: %C4K_EBM-4-HOSTFLAPPING: Host 00:15:00:13:C9:5F in vlan 251 is flapping between port Gi2/2 and port Gi2/1Mar ...

Hello,Can anybody help me to configure rate limitting on my 3560 interfaces? I tried to apply a policy-map to an interface and the switch accepts service-policy input but not accpeting service-policy output. Even the switch accepts input policy, it i...

Hi Experts,I got 5 switches and cuurently running spanning tree. But, I want to change them into single Vlan 500. Just wonder, is there any issue??