I connected one layer 3 switch to Hub as shown in the attached fig.I want to know which port will be come designated port, non designated port ,root bridge and root port.
Everyone, First, here is the setup: 2 6500's with dual Sup 720's connected together with dual Gigabit etherchannel 802.1Q trunks. Redundancy mode is SSO/NSF and they run in native mode Each router runs HSRP for the VLANS shared between them. One is ...
Hi I'm currently preparing my BCMSN certification exam. Follow my reading I need more explications on some topics. Also I'm am a French people and some time because all documentation I have are in English some times it is the English it self my un...
I have installed new nodule WS-X6148-RJ45V in slot 13 of cat 6513.. It is show in show module.. But If I configure any thing on that module, I don't see that module in show config.. Any suggestion??
Hi AllIt appears from reading the blurb on the 877 model that the ability to create extra VLAN's (other than VLAN1) depends on the IOS ordered. It appears that only 1 VLAN is supported unless you have the Advanced IP services/Advanced IP Enterprise I...
HelloI have a Cisco 876 router. I have created an extra VLAN, number 2. I have assigned an IP adress and 2 ethernet ports.For the IP adress of VLAN1 is automaticly an IP route created (C = connected). For VLAN2 this is not?! I also can't create an st...
Hi,We need to clarify that which type of cable is required to interconnect Cisco Ws-2960G-24TC-l with ws-c3508G-XL-EN series switch let me know how to connect a ordinary ethernet port with GBIC port, Normally we use crosscable to connect two switches...
Platform : C6506, 2xSUP720-3B, 122-33.SXH1Linecards : SW-X6516(2),6516A(2).SSO on.Command : show fabricResp : switching Mode = CROSSBAR for Mod 1,2,3,4,6- dCEF for mod 5 - Where can I find some explanations about CROSSBAR in 122SX ? I know crossbar f...
Hi to all, My network topology is as shown in the gif image attached (mySetup.gif). I want to load balance traffic coming from the Internet and destined to Host A onto the four firewalls (A,B,C,D) connected to the switch on a per-packet basis. For th...
Hi, I would like to block the snmp traffic generated from to PC and coming into my interface ATM PVC on my router.the ip addresses are 10.10.10.202 10.10.10.123.What is the best ACL that I can applie?ThnaksRegards
Hi,can someone help me with this problem?:I have a cisco network with 20 branches and a central site. In my network is a device with address 169.254.X.X, what is a address for computers that haven't assigned DHCP address. I need physically find this ...
Hi,We have two links between HQ and our Branch, one is active and the second is standby and there is HSRP between the two routers connected to both links.We want to distribute the traffic between the two links, so we decide to route some services to ...
