Switching

Here is my situation, I have a Cisco 2600 with a modem bank and VPN access. I also have a proxy server which only allows internet access to a certain range of IP addresses. Between internet, non-internet, and static addresses my internal network ip a...

Hi,I have SUP1 failure for 6513 switch. as of now it working on SUP2. below is sh module result. please suggest the step to recover the SUP1 back online IB3-6513-2-2 sh moduleMod Slot Ports Module-Type Model Sub Status--- ...

Hey, I have an issue that I need your assistance. We have a router that is doing tunneling for both voice and data traffic. After a prot went bad we changed the configuration, to another port. Afterwards we had problems and found that the voice i...

Hi,Need some guidance, I have a Cisco 2600 router I want to configure for routing traffic from a local lan and remote site to sites. The remote sites address are 192.168.53.0/24 and 192.168.54.0/24 the local lan address are 192.168.50.0/24 and 192.1...

Hi there,Is it possible to setup a 2950 for HTTP Read Only access without a prompt for Authentication. If not, how can I set up a logon that would allow just Read Only accessCormac

hi, can any1 tell me a free tool ( windows ) to take bulk configuration backup, i found cirrus to be extremely useful but its not free so if any1 can help me out in this ?thanks in advance

Hi all, what does this light mean, if I have a carrier detect light but no line protocol what does it mean, can the circuit be active if the lp is down? also say if its an isdn line, how would I know its active would the lp be off or on ?

Hi all, if I have 2 routers using hsrprouter 1 ip is .1, routers 2 ip is .2virtual ip is .3when I do a traceroute to a destination, I see the path takes ip .1 then .2why is this ?

HiI have a question about DHCP server on cisco routers. I want to change the source IP address for the DHCP server to my loopback interface on the router, is that possible. For the client it should look like another server sent DHCP offer and ACK.I h...

Hello can any one have an Idea of binding IP address with MAC in DHCP in cisco router and switchsThanks in advance

hi,I would like to ask the difference between class based queueing and weighted fair queueing?which one is the recommneded to use?

I have a question regarding what the default gateway of a host should be.A switch has IP's for 2 vlans including the management vlan. This switch also has a default gateway statement pointing to the router interface. This is a switch at one location....

I notice that many vlan & vtp configuration commands don't appear in the config file for integrated IOS. What's a quick way to see and back up the current vlan & vtp configuration information? Ideally, what I'd like is something like the config file ...