Switching

hi,if i use the following command" fabric switching-mode allow bus-mode "1, will it reboot the chassis and sup720?2, is this the right command to change the switching mode from dcef to bus mode.

I have problems when natting ftp on a standard port. My router do source and destination nat because my net and external net are overlapping.So i created an access-list and a route-map do identify traffing to be natted:ip access-list extended A permi...

Bonjour, I get in touch with you to make an inquiry. I have a telephone Cisco 7940, I want to use through a single Ethernet cable and power PoE. I connect the phone to a switch PoE but I do not know how is the braided cable Cat.5 before you can use...

They port will not show up in the router config. When I put a WIC-1DSU-T1 V2 the port shows up.

Hi all, am i right in saying that if I had 2 switches plugged together, each switch wouldnt know about each others mac addresses until a host is passed through the uplink, can anyone tell me how the switch knows to use the uplink to find the yet un f...

Hi there! I will appreciate it very much if someone can help me with the following question. If you use opposite currents, can you still send data in one direction?What I'm referring to is the fact that the pairs of wires in UTP cables are twisted to...

Are the uplink ports 1 gig or 10 gig.If they are 10 gig, can I connect them to a 1 gig router interface?

For the output of show port 5/20...Port Security Violation Shutdown-Time Age-Time Max-Addr Trap IfIndex----- -------- --------- ------------- -------- -------- -------- ------- 5/20 disabled shutdown 0 0 1 enabled ...

Hello,I've got a Zyxel router configured and connected to my SDSL line and all is working fine. I've purchased a Cisco 878 router and want to try configure it firstly just for internet connection and nothing else.Are there any very simple guideline i...

This is what I am trying to do:Switch 1 ----> Crossover ----> Switch 2Switch 1 has an IP of say 22.110.250.2I put Port 10 into VLAN 60 and connect it w/crossover to port 10 of Sw2.For switch 2 I give it an IP of 34.120.250.2I put port 10 into VLAN 60...

Is there anything special that needs configuring for receiving Multicast through a FWSM running software 3.1x? Multicast routing is enabled and the correct RP is defined. We have the appropriate ACL's configured to allow PIM, IGMP & all Mutlicast g...

Dear sir, iam having 1720 router in that i natted private ip with public ip now the problem is i have one exchange server inthat 192.168.10.254 now how can i resolve the private ip to public ip.i want accese that server from outside network.plz give ...