Switching

I have 5 units on a vlan on the same 3750 switch in a 4 switch stack. 4 of the units require a BootP response from a BootP server that is unit 5. They are MAC Address packets sent from the units and are not being broadcast over the vlan. Any trick...

Hi all, im configuring 4 vlans on my wlan system, do I need to put the port to my AP's as a trunk ? and if I have a dhcp server, do I just use the helper address command on each vlan and create the scopes on my dhcp server ?

I just purchased the Cisco 1841 Security bundle w/ a T1 WIC and also purchased the WIC-4ESW card, but the ports are not recognized. According to the WIC-4ESW says minimum is 12.3(8)T (fourth release of Cisco IOS Software Release 12.3T). My router's...

Hi,when appliying QOS to WS-X6548-GE-TX and WS-X6516A-GBIC with a Sup32 (12.2(18)SXF7) the following error message is displayed: %C6K_PLATFORM-6-PACKET_BUFFER: This setting will cause a packet buffer error to take default action on a affected module....

Does anyone know of any OID's or MIB's that will provide me stats about a switch trunk? Thanks.

We're deploying a number of CE500's as part of my client's migration to Cisco switches. However, I am having some issues with trunking or port security (just can't pin point the problem), in that there are cases when two PCs can't see each other even...

Hi all, my new company i work for uses AS2, can anyone tell me what AS2 is or does ?

Is it possible to change the OSPF path cost of a single route on an incoming interface so that it will be placed in the routing table in preference to the others. If so how's it done.I have the same route coming in several interfaces that are equal a...

I've been reading a bit about the dns proxy feature but am not sure if it would do what I'd like it to do. In one of our small offices we have an 871 (with 12.4-11.T1 Adv IP loaded) that serves as the perimeter router and also does basic firewall d...

I have 2 border routers, each connect to a different ISP at about the same speed of 20mbs. I only get a default route from both the ISP's. I use HSRP for a failover so all the traffic goes out the main router.Is there a better way to do this? I'm afr...

Can someone explain what a mode conditioning cable is used for?

Other then the banner motd is there any way to add messages that would appear at log in on a switch?

Would it be a good idea to make a seperate vlan for spanned traffic so it does not recieve broadcasts?

hi,I have a question about le release note 12.1(22)EA9 for the cat2950. I found that this release is just below the versions 12.1.22-EA8a.for exemple:12.1.22-EA8a (ED)12.1.22-EA6a (ED)12.1.22-EA5a (ED)12.1.22-EA4a (ED)12.1(22)EA9Why the download page...