Switching

I am trying to enable port mirroring remotely via SNMP, on a layer 3 switch. I can't find the OID anywhere, to know if it is even read-writable.Does anyone know?

Hello Team,i am using cisco 1300 Switch and getting error given below, when trying add interface description and ACL. please help me on this.Error:-% Wrong number of parameters or invalid range, size or characters enteredip access-list 81 permit 57.2...

Good day, I have a cisco C1000 switch, and it is showing output errors. There are no other errors on the interface. this is happening on several interfaces. I was thinking the buffers were overflowing but there are no errors on output buffer failures...

Hi, does anyone know how to view VTP password after configured for Catalyst 9K series? The password can be seen via the output of "show vtp status or show vtp password".

Hello, we are currently in the process of migrating to the new Cisco ISE appliance. As part of the process, we change TACACS+ configuration on all our devices. During migration we’ve encountered problem with our Cisco Catalyst C9500 core switch, whic...

I have tried everything, updating to latest firmware, cofig'ing spanning tree. i have the ports i want to use for the APs on LAG. However, nothing will power these APs. I see the switch is capable of 802.1af like the APs want. But what am i missing h...

Hi folks,I have spent the last couple of days trawling SL documentation but have failed to find the instructions to do this.All but two of our 9300 switches worked with Smart Licensing Compliance via DNA Center. The two that failed said:Provisioning ...

I inherited about 20 - about 10 each of the CISCO 9300X 48TX-E and C9300L-48P-4G-E switches.  Not sure why they were purchased, but they are sitting in boxes.  I have a need to replace some old Dell Top of Rack switches that have memory leaks.  If so...

I have a cisco 3750X-48P switch and a D-Link DPH-400SE phone, where the phone is connected to the G2/0/35 interface, with the configuration below:interface GigabitEthernet2/0/35switchport access vlan 153switchport mode accessswitchport voice vlan 99n...

Hey guysI'm looking for some help.I'm creating a new project with an ESP32:I want to read all my systems at home (heating system, electricity meter, water meter, ...) via modbus tcp and than write it into my database via API. For the hardware I chose...

I recently noticed that my IPv6 multicast traffic was being broadcasted to all hosts connected to a switch, even those that had not subscribed to the traffic.To fix this, I enabled MLD snooping on the switch, and this fixed the issue - now only those...

I have a LAN Base license on my IE2000 and the EEM isn't working. It was working a while ago when I was testing out some scripts, but now it isn't. I'm using version 15.2(4)AE5. I don't know much about it, and I think it was because I've reset the sw...