Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello everyone, I have an issue with my setup. I have two Cisco C9300X-48P switches running IOS version 17.12.9, configured in a stack. The problem is as follows:The switches are connected to servers via dual links (one from each switch), with LACP c...

Hasaki by Community Member
  • 166 Views
  • 6 replies
  • 1 Helpful votes

Hello.After a small power failure, one of the Nexus 9k, after loading, began to reboot after 5 seconds and so on in a circle. I decided to reset the configuration via boot loader, as a result, now the system does not load, I did this at the start of ...

12.png 13.png

Hello everyone,I hope everyone is doing well.I was looking at some q-in-q concepts and if anyone can tell me what i am doing wrong i would be forever grateful.Topology:SW1:interface GigabitEthernet1/0/8 switchport access vlan 1024 switchport mode acc...

DragosMariusAvram66611_0-1751227773294.png
milo34 by Level 1
  • 243 Views
  • 5 replies
  • 0 Helpful votes

Hello Team, FAM!Attached is my high-level topology between DCs, need help setting up vxlans, Please guide me ,  

fmugambi_0-1749539923298.png
fmugambi by VIP
  • 324 Views
  • 5 replies
  • 0 Helpful votes

Hi Dears I am connecting Huawei switch with Cisco nexus9k switch. When I enable vbst stp mode in Huawei switch then traffic seems not working. When I run mstp in Huawei switch then it's working. Cisco is running pvst in  both scenarios.  I am wonderi...

Faizandoger by Community Member
  • 363 Views
  • 13 replies
  • 0 Helpful votes

Is the plug standard of the power cord CAB-TA-JP used in the C9200L-24T-4X-E different from that recognized in NEMA 5-15?The power cord diagram can be seen below, but we would like to see it without any explicit description.https://www.cisco.com/c/ja...

Translator by Community Manager
  • 123 Views
  • 2 replies
  • 0 Helpful votes

Hi guys.I have two questions regarding STP1-Why have an alternate path in STP?STP keeps redundant paths in standby in case the current path goes down right? But, when a link failure occurs, the STP is recalculated. So, what's the point of having an a...