TelePresence and Video Infrastructure

What is the command syntax to get the mac addresses of the interfaces for the Acancno X3 to get licensing from ACU to CU .. I am running cms 2.6.1 now on the CMS's  and need the shared multiparty licensing fixed ... Any help is appreciated.  

Hi, I have Telepresence Conductor 2.3 version deployed in BE6k.We have deployed it in 2015. We have forget its admin(administrator user) password. we reset its password with pswre command.After resetting the password of username admin, we are unable ...

Got CMM 2.6.0.339 up running ... Performance observation. 1. TMS VM windows 2016 version 15.9.02. CMS Acano X3 2.6.13. CMM VM 2.6.0.339All CMM and TMS VMs co-located in same building.CMS in different building on same campusNO Firewall involved.  Prob...

Running TMS 15.9.0 Running CMS 2.6.0 I am trying to get CMS connected to TMS but it's not working ... TMS uses port 443 HTTPS to communicate with devices. Well the CMS uses port 445 on the Admin interface  and it's not working ??? When I try to put 4...

Running CISCO Meeting Manager 2.6.0 Licenses issue1. Licenses page  Cluster - Shared Multiparty Plus  "Out of compliance" Not sure why the licenses error.  CMM is communicating with the Cisco Meeting Server 2.6.1 The CMS software is installed on the ...

Setup: I have installed CMM 2.6.0 and receiving the following warning:Cluster (CMS1_cluster) is 2 days out of complianceLicense SummaryShared Multiparty Plus  (Status out of compliance) The CMM has one Acano X3 running CMS 2.6.X  (Perpetual licenses)...

Running CMM version 2.6.0.339.I just tried adding my private key  and public CA.It indicated the key matches the certificate but when I select save I get Failed to update settings .. ?? Any Ideas folks.???Thanks.

Hello,   We have SX80 CE9.6.x, Dual Camera (No speakertrack, third party controller) registered with CUCM 10.5 The Meeting room is a big hall and both camera  are facing different area of the hall, I understand One endpoint stream video from one came...

Cisco CTS-QSC20-MIC will not unmute, but will mute, from the button on the mic when connected to our new Webex Pro Codec. We sre using CE9.7.1 firmware.  They do unmute from the touch 10. Is this issue fixed in a later version of firmware?

Hello community, Is it possible to register our Cisco codecs SX80 to expressway-c instead of CUCM? If it is possible what is the type of license we need to buy to activate this feature? Thanks

Hi, We have an SX20 Cisco VC and we have some issues with the microphone. I wants to deploy an external microphone/speaker that would be placed on Cisco system (it will be far from users by 4 or 5 metres) .The table is rectangular and can seat approx...

Hi Does anyone have the physical dimensions of the cts-disp-65-gen4  displays ? I was wondering if anyone has replaced these with something other than a plasma and if so what works ?

Hello Everybody I have a big confusion here in Cisco Webex hosted and Cisco Video Conferencing Infrastructure. I have 5 sites across the world and the  requirement is the managers wants to do a Video conferencing with internal and external corporate ...

Good day, A client of ours is seeking help to move their VCS from one building to another building. I would like to know what are the impacts involved from doing this move to another location. I know that:-  The IP Address will be changed- Endpoint w...