We have 3 UCS C210 M2 running ESXi 5.5, how does Cisco handle the updating of the hosts to the latest version if the hardware is on the VMware HCL? These are running our Cisco CM and Unity 9.1 VM's.
I recently started a new position where we have three UCS C220 M3 servers running ESX 5.5. The three are in a cluster and share datastores on a NetApp appliance. Each server has two 600GB HDs installed. My predecessor left a note stating that one ...
HI,
We would like to change the name of vlan in UCS. We didn´t find how we do.
Our configure is:
scope eth-uplinkcreate vlan oldname 3275
scope org Virtualizedscope vnic-templ ethx.dvsVMs-Acreate eth-if oldname
scope org Virtualizedscope vnic-templ...
Correctable ECC errors should not flag DIMMs as Inoperable or Degraded : CSCuw44595
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCuw44595/?reffering_site=dumpcr
TAC engineer claims that infrastructure AND blades have to be migrated to 2.2.7 to fix...
I have completed the Auto install process a few times, but most have been with minimal production traffic in place. I have one scheduled for this weekend and would like clarification on whether it is best practice to shutdown the network and storage...
Could you please direct me towards documentation on the Cisco website that would describing the process and steps to be take when updating from ESXi 4.1 to 6.0 for the UCS C210 M2 hardware.
Is it simply a case of applying the following file update to...
Hopefully, this is a simple issue. I'm working with several C220M3 servers where we have installed a VIC 1225 in each server. The VIC is configured and working. We have a requirement for a 1gb NIC and would like to use one of the two built in NICs (L...
Hi,
I just purchased some new hard disks (total: 5 x 500GB HDs) and plugged to C220 M3S server, which is running the BIOS version as C220M3.2.0.1b.0 (Build Date: 05/26/2014). I cannot select the option as RAID 10 on the below photo. Any idea?
I have power issue logs shown in my UC220 server and it gives in server overall status " Server Fault "when i check the logs i found the following :PVTT_P2: Processor 2 voltage is lower non-recoverablePVTT_DDR_GH: Memory channel (GH) voltage is l...
Hi All,
Its new installation of Cisco UCS with Brocade SAN switch 6510.
I have followed the Cisco UCS to Brocade Connectivity Guide.
Even though the on both Switch and FI side the Link is not coming up. No lights are glowing.
When I checked the s...
I have one C series server in a lab and I want to manage it with UCS manager but I have no other UCS hardware. Can I install UCS manager in a virtual appliance and use it to actually manage the physical server (not just emulate UCSM) or do I have to...
