Unified Computing System Discussions

Hi all,i got a UCS C200-M2 with an additional LSI 1064E raid card, the storage has been build as Raid 0+1 with 4 500GB SATA HDD, i try to simulate a disk failure situation, which is swap one HDD with a brand new HDD. The raid card can detect the new ...

So currently I am installing ESXi 4.1 on a C210 M2 series server. The basic install is completed and I am configuring the networking. I have two VLANs 10.1.152.0/24 (VLAN 152 Voice) and 10.1.153.0/24 (VLAN 153 Mgmt). The trouble I am having is I am u...

My customer is seeing loss of access to FC attached SAN on b-series blades that have windows and Red Hat installed bare metal, VMware are fine just these 2 OS's.  It happens when the 6100 fails over to the subordinate.  They say they reboot the serve...

Hi. Cisco gurus:May I have the authoritative answers on the following?1. What is the Use Case of FC Port Channel under SAN Cloud assuming I have the typical Cisco VSAN setup-1 VSAN tied to 1 SAN Switch and 1 FCoE VLAN and another VSAN with diff. VSAN...

I have been stuck on setting this server up for a couple days now.  I have never had such issues with installing a server before and can't figure out what i am misssing...I am able to load the Windows software to the point of Where do you want to ins...

Hi I would like to know the procedure in renaming a given UCS.We need to rename the whole cluster , and i want to ensure we renamed across the cluster  - where -ever the old name exists.Could some one please share the details.ThanksVamsi

Is it possible to connect both ethernet switch and FC switch from 6120  Fabric Interconnect using the 8 port extended module?

This is funny but I have't figure out what is the problem.I have the SAN pinning setup as follows:A1 uses fc0 on 6120XP fabric A A2 uses fc1 on 6120XP fabric A B1 uses fc0 on 6120XP fabric BB2 uses fc1 on 6120XP fabric BAll the left side blades (slot...

Hi!We are using SNMP on UCS and our monitoring works fine. The only "annoying" thing is that about every 20 min there's an Authentication Error message in the logs on both 6120's:Trap received from  xxFIPRUCS-A[10.137.0.xx] : SNMPv2-MIB::authenticati...