Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
A customer of ours is requesting this scenario:
DN 1000 (GM) to get calls from C-Level (DNs range from 1100, 1200, 1300, 2000 ..etc). and forward other calls to the secretary 1001
Is this scenario possible? How can we achieve it ?
Thank you!
Hello,
I'm facing an issue of APs (different models) not joining a newly installed vWLC (v 8.10)
The APs were previously joined in WLC 2504, but the 2504 failed and we cannot repair it.
So we configured a vWLC, but APs don't join. These are the log...
Hello,
Is it possible to mix different RSPs (880-TR & 880-LT-TR) in an ASR9K ?
Is there any document mentioning not mixing (I couldn't find any)?
Thank you!
Hello,
I have this scenario with a customer and I'm not sure how to apply it.
Is it possible to make the 2 FXO lines on Site A only accessible for users on Site B?
Meaning users on Site A cannot use these 2 FXO lines.
Thank You!
Hello,
I'm working with a customer that has 2 branches each with CME (ISR4000 with CME 14.1), and I'm trying to configure them to reach each other to enable users on branch1 to call users on branch2 and vice-versa.
Both branches are connected to e...
Hello Flavio,
Date and time are correct (I even tried the workaround of changing the time).
License is activated (it is evaluation and it is enabled).
Country is correct.
Reachability is ok, both can ping each other.
I will factory reset the AP and g...
I faced the issue with 3.1 and tried many browsers with no luck (Safari, Chrome, FireFox, Edge, IE ..)
It only worked on this portable version of FireFox (FirefoxPortableWithFlash18).
Check this release note (section: About Cisco Expressway Licensing)
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/expressway/release_note/X14-0/expressway/exwy_b_cisco-expressway-release-note-x14-0.html
