Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are running CUCM 15.0.1.12900-234. We've noticed that sometimes DRF doesn't back up TFTP files on one or both of our TFTP servers (while it's possible that TFTP won't be backed up on either of our two TFTP servers, it's more likely that only one ...
We finally got the chance to upgrade to CUCM 15 last week. The annoying little issue we have now is that the new RTMT opens a command prompt window behind it that shows a bunch of script scrolling by. If we're monitoring multiple clusters that's mu...
When issuing the command "utils dbreplication runtimestate" three of the servers in my cluster show "N/A" in the ping column. The servers have a "2" listed in the replication column and they can be pinged from the publisher by IP and by hostname. I...
We have some new 8300 routers that we're using as voice gateways. When configuring SRST, does anyone know how many phone numbers can be put into a parallel voice hunt-group? I'm seeing it's 32 for CME, but I don't know if that is going to be the sa...
Just realized I forgot to mention that there were a bunch of services that may or may not have needed to be restarted, but we did restart them. They can be found in this mindbogglingly helpful link which is worth looking at no matter what. It has s...
This post is rather old at this point, but I wanted to update it because I found a solution. This issue has happened to me on two occasions now, so I'm assuming others might have seen it also. However, I should point out that my solution was to an ...
This is an extremely helpful article. The only comment I might add would be that I always DO disable and then re-enable SAML after adding Tomcat certificates. If something goes wrong with it (as has happened a couple of times) I know the cause. Th...
That's the thing, the backup doesn't fail. It just doesn't back up the TFTP information. When you start a backup it shows you the servers that will be backed up and the modules that will be backed up. It doesn't show that it's going to back up the...
I know this is an old post but I was having this issue and none of the other posts addressed the solution I found. In my case the problem was also that port 7993 was not active. I discovered this by using the CLI command "show open ports all" and s...