Voice over IP

Hi all,I have a solution that connect 2 pgw's with one as5400, the TDM switch that have ss7 are connected to the as5400, and they use the TS 1 for signaling, I have configured my as5400 e1 as follow:controller E1 1/0 framing NO-CRC4 pri-group timeslo...

Hello,I'm looking for tool to edit Cisco unity 4 voice sound.All audio edit tools I found didn't recoginze the unity codec

Hi all,Can any one point me in the right direction of a config/design for running SC220 to interconnect our 1000 x 0161 ofcom allocated numbers wth BT?We are running an AS5300 for our gateway with 4 x E1 ISDN lines.Many thanksRob

Hi,Does anybody has the decoder973.pl file to install the VSPT Patch?, is request is due a downtime in cisco servers and I need to finish an installation, but the VSPT is not working properly and is a bug.Thanks in Advance

Hi all,I'm trying to figure out how it's possible to set the name and label with characters like öäü (eg. label dürüm). The IOS version is 12.4(11)XJ3 (CCME 4.1(0)).With the IOS 12.4(9)T (CCME 4.0(0)) it was working (through the web-gui).Any ide...

Hi!, I have a AS5800 and I'm thinking of using it for PBX/VoIP setup. Currently it has a 2pcs CT1 card, do I need a specific card for my setup to work?

HelloI am sending call from a Nextone SBC to an AS5400. The AS5400 is routing the call but not putting any CDN into the ISDN setup message even though the incoming invite has the TO header populated with the numberI compared a good call to a bad and ...

I have two site configured. Site A is connected to the Service providers end (FXOs and NM). Site B has FXS and they are configured as per the attached files. When we call from site B, the calls go through fine but there is no ringing. when the call i...

We are getting Voice Spam on our VoIP systems. We're currently using Cisco Call Manager 3.3 Is there any ways to block incoming calls from an outside source?

What equipment do i need to create a SMB voip network , there are 3 locations , 1 of them with 100 ip phones + 100 PC , 2'nd location with 50 phones and 30 PC, and the last locationa has only 2-3 phones , no PC. Thanks.

We have the following VoIP setup:Site1_PBX---VoIPgw--**network**--VoIPgw--Site2_PBXISDN type: E1 PRIBoth gateways have 03 E1 PRI setup, so total, we have 90 B channels. It seems the router select the B channel randomly. We need to have a logical sequ...

How do you set a 7941 to show Caller ID name as well as the number? It is coming in to the system but not being displayed on the phone.

Hi,I try to develop TCL script that will disconnect call with cause 34 immediatelly when call reaches dial-peer that tcl-script is assigned. To be more detailed: dial-peer that tcl application would be assigned should be outgoing voip dial-peer on Se...