I am trying to use our GIC service with SPA 525 phones and it looks like the phone is stripping the leading # off when I dial # and the GIC number. Has anyone else ran into this?
I am having issues with the devices downloading firmware from http.I have the following set<Upgrade_Enable ua="na">Yes</Upgrade_Enable><Upgrade_Rule ua="na">http://myserver.com/spa122.bin</Upgrade_Rule>And none of my devices ever contact for new firm...
Hi, I have an SPA232d which I can access the Phone Adapter Configuration Utility login page for through the Ethernet port but am not able to login in as either admin/admin or cisco/cisco, I get "Invalid Username or Password. Please Try Again.".I have...
Hi
I am using the ATA SPA232D to accept incoming PSTN calls, the call asterisk, which then forwards the call to FXS (Line 1). Incoming calls are connected and voice works in both directions. But the Phone on Line 1 does not show the Caller Id.
Some...
Hi using SPA112.Device stops responding the calls (I see that the Line1 is registered) after a while. Unless I do a Factory Reset for voice setup, device does not respond to calls (phone does not ring and the calling party receives busy tone) but I c...
Have recently installed an SPA112 VoIP adapter. It is able to receive calls but cannot send them. Am certain there is something missing in the set-up but not sure what? Any help would be great please.
Hi we have a cisco UC520 I want to configure a voicemail while support extension is not available all incoming calls should be transfered to this announcement also from support poste transfer should be dine by softkey.Thanks
I have a SPA9000 and I'm using two lines (out of four). One from my internet provider, which needs the VOIP wan, and the other from a SIP provide, over the Internet.Also, I have a two WANs router (one for the internet and one for the VOIP). So, If i ...
This is not a new question ... our IT guy as gone and left us without username and password to access the UC 320W andno configuration backup.It's possible to recover the access to the UC320W without loose the present configuration ? I saw that an ans...
Hi,Not sure if this question is right but can I use the SPA112 2-Port Phone Adapter to connect a PSTN line? What I want is, I should be able to choose a line and while making calls. Use PSTN or VOIP. Please let me know if I am using a wrong device...
Hi,I've a SPA8800 registered to SIP proxy provider.I want to know if it possible to forward call from internet port(WAN) to FXO(Line) port. if so, how to do it? Many thanks
Hi,We have an SPA232D which has been set up as per the instructions that came with the device and also found here: http://www.cisco.com/c/dam/en/us/td/docs/voice_ip_comm/csbpvga/spa100-200/quick_start/SPA232D_QSG-en_78-21580-01.pdfI confirm that all ...
Can't pin this one down. uc560, Running: software pack 8.02 - CME 8, CUE 8.06 - yes, I know its old.We added a new 7975, it would not register, discovered that the term75.default.load file had bad info in it and the tftp lines for the 7975 were als...
Hello,I am new to configuring Cisco VoIP, I've read around the forums and I am eager to learn more.I need help on the following situation:Setup:- UC560E1 PBX.- local phones SPA512G and SPA502G on the same subnet as PBX.- branch office phones SPA512G ...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
