We recently updated our UC520 to software pack 8.0.2. IOS 15.0(1)XA2Since the upgrade, the phones have a very distorted ring, followed by a fairly loud click.Voice call quality is fine.We had a similar problem on 8.0.0, except that voice calls were ...
HiI have a customer who wants calls returned to receptionist if no one answers after a blind transfer. Is that possible within the UC500 and how?The receptionist has a sidepanel.Thomas
Does anyone know if whisper intercom works with a spa525? I have a 7945 in which I can get it to workbut on the spa525 I can not get a whisper intercom to even show up on a button, just like the command is not even there under the ephone...
Hi, is it possible to connect a vg204 to UC520?The old ATA should be supported, but want about vg202 and vg204. Have anyone done it and can they give som e hints?Thomas
Hello!Is there a simple explaination in how to set that Scenaria up?I am a bit lost.. i know that CCA doesnt support it yet... can anyone guide me please?i got 8.0.2 Software Pack.Thanks!
Hi,i will be aborad for 3 months an will call into the home phone net over my spa9000 system. I have a wrv200 router and we are using nat translation. Which ports do i have to open for registering a softphine like x-lite to the spa9000? I will try th...
We recently installed a new internet connection in our office that we have not cut over to yet. I am wanting to terminate it on the UC500 and am having trouble finding information on how to create static NAT entries on it like I have configured on ou...
just replaced a partner system. Warehouse building.Can I connect the page wire to any fxs ports and setup paging from the uc500?
Over night, only one phone was rebooting, the others were fine. As the day progressed multiple phones were rebooting. Did a packet capture of /all/ traffic to the public ip of the phones from the SIP server to see what was going on up to 5 minutes be...
Is the CUE configuration and messages included when you perform a Configuration Archive from within CCA?Thanks
Is it possible to see users on the remote site with a UC500 multisite setup?
Hi Marcos & Team,Our UC520 supports a few PCs, 79XX phones and integrated WLAN, also two analog dial-tone door bell speakers. Now we'd like to install 4 7925G Unified Wireless IP phones for a bit more convenience and maybe install a couple of SPA525...
Is there any reason for not using the UC5x0 in conjunction with an existing 3500-series switch? Don't need PoE, happy to configure using CLI ....
I have a customer where the onramp service has been successfully implemented and there are four users receivng fax-to-email. When I setup one of the users I failed to set the notfication preference to All Messages from Urgent Messages. CUE is showi...
Hi ,I tried to integrate CUCM 7 with CUE modul in UC500. When I wanted to add JTAPI parameters I faced with license problem:UC500-CUE(config-jtapi)# ccm-manager address x.x.x.xOperation not allowed with current installed licenseHow to find out what k...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: