Greetings everyone, I have a particular customer who is requesting that when a inbound call is received that it stays on the SPA 303 phones screen for an extended amount of time after hangup so they can copy the inbound call into a spread sheet. T...
Greetings everyone, I have a particular customer who is requesting that when a inbound call is received that it stays on the SPA 303 phones screen for an extended amount of time after hangup so they can copy the inbound call into a spread sheet. T...
Hi EveryoneI have an SPA122 that I purchased from Teksavvy in Toronto, Canada, for use with their VOIP service. I have since changed VOIP providers and I'd like to reuse the ATA but it seems to be pre-populated with their info, or at least it provis...
Hi all, I have SPA525G (Colour Screen) handsets that were installed to run with the NBN (Aust) network. When I had the system installed a Cisco (or Telstra) rep kindly installed some management software onto my computer to allow me to manage the han...
Hi all, I have SPA525G (Colour Screen) handsets that were installed to run with the NBN (Aust) network. When I had the system installed a Cisco (or Telstra) rep kindly installed some management software onto my computer to allow me to manage the han...
I have recently purchased a SPA122, new in box, unit configured to Hughsnet service and need to access the setup to configure it for my service provider. I was unaware that this was a branded unit before purchase. Can anyone help??
I need a list of all my phones with serial, extension, and user. we are running CUCM10.5.1.10000-7. Any help. the inventory lady is driving me crazy
CUCM 10.5 When I looked at the IM&P presence topology, it still thinks that it is connected to the old IP address of the CUCM. How do I fix this? thanks
Hello friends I have a little problem with one device spa504g , I've done some configuration inside of this telephone , update of leguage Spanish , then my device SPA504G reboots quickly, then it appear a message checking dns and reboot again, s...
Hi! Verifying the quick start guide and comparing it with config templates there is a typo with the interface OR my config template is not valid to factory version: http://www.cisco.com/c/dam/en/us/td/docs/voice_ip_comm/cucm/BE6000/78_docs/10_5_1/BE6...
Hello all I'm having Problem with SIPURA SPA3000 connected to elastix. Whenever a landline call received by SPA3000 then transferred to external sip phone eyebeam, the call is dropped. Sometimes silence in the caller side. Specs:SPA3000 firmware 3.1...
Hi,My SPA504G reboots over and over again. It says Initializing Network, Checking DNS and then reboots. I removed all the cables except power to see if its a network issue but its not. There is not way to stop it.This device was working without any i...
Hello friends I have a little problem with one device spa504g , I've done some configuration inside of this telephone , update of leguage Spanish , then my device SPA504G reboots quickly, then it appear a message checking dns and reboot again, s...
Hi, I purchased a Cisco SPA 122, I didn't realized it was provisioned with Peoplefone service. I asked Peoplefone how to unlock the unit and they answered me to ask Cisco. Here I am, how can I unlock SPA 122 in order to use it with different voip pro...
One of our users (and I believe others have expressed this issue before) is having people on the other end of the phone hearing buzzing. The audio sounds fine to her though. The SPA504G is using load 7.5.2c on a UC500. The only thread that seems s...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: