VPN

Hello, I had two questions about remotely login to switch or router :1. What is the default setting on switch or router to accept remote login (i.e., telnet or ssh)2. If i configure...TRANSPORT INPUT TELNET SSH... which one is default and accepted fi...

What should be the certs installed or included for ssl vpn. I typically see identity cert getting renewed every year ( before it used to have 3 yrs validity), but along with it, should I update the intermediate and root cert as well every time?What i...

Hi all,Just a quick question that I wasn't able to google the answer for.Our FTD pair generates a lot of Informational logs every minute related to:"IPSEC: An outbound LAN-to-LAN SA (SPI= 0x3E10868E) between 192.168.100.2 and 192.168.100.1 (user= 192...

HI All, I have a Cisco 1941-SEC/K9 router and I would like to check if it has site-to-site and SSL VPN features enabled. Could you please let me know what command I must run to check if these features are enabled? Thanks

I am planning to enable Hostscan on ASA to verify if the Windows devices comply with the security policies or not. One of the requirements my customer requested is to ensure that all devices are to enable Windows Update automatically. Also, the devic...

I am trying to renew SSL vpn cert on FTD through FMC. I am following the guideline "Install and Renew Certificates on FTD Managed by FMC". I am doing the PKCS12 Renewal. I created the CSR and now received the cert. There are two commands in Open SSL ...

We have an FMC that manages two FTDs both running 7.0.4. AnyConnect 4.10 is the VPN client we use. All our users are setup as a local realm (No AD integration) I was exploring the canned reports that come with the FMC. Has anyone tried to generate a ...

Cisco AnyConnect is constantly connecting and disconnecting when the user starts up each morning. eventually it connects permanently. See the screenshots from the event logs and also from the VPN message history. Searching through the DART bundle at ...

let's say inside network A is 10.0.0.0 /24 and the peer on the other inside is 192.168.1.0/24. Would a static route on each make each peer pingable and see each other? Or is this mainly done via the ACL? I am expecting NAT should be turn off on the v...

Has been able to F5 GSLB to load balance AnyConnect SSL remote access VPN or is there a guide anywhere?  We currently have two ASAv50s deployed in our two main data centers and we want to be able to use our F5s with GSLB to load balance the traffic b...

Hello,I'am trying to access via vpdn to my cisco router ASR1002x from my iphone but that's not successfully ! I'am using VPDN setting and its work on my windows pc but not on my iphone the config that i use is : vpdn enable!vpdn-group 5! Default L2TP...