VPN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco CyberSecurity

Labels

Forum Posts

I had another thread going, but when I got past my current hang up, I marked the thread as answered, so I wasn't sure if I should start another or continue on...         I've tried going through that troubleshooting doc, but I still can't figure this...

Hello,We have an HQ site with a 2811 (w/ADVSECURITYK9-M) acting as the firewall. We currently have 1 ASA5505 that has an established ipsec l2l VPN. I'm trying to connect a 2nd ASA, but I've noticed I can only add 1 cryptomap to the outside interface....

I have over 60 hours invested in trying to figure this out.I have an ASA5505 that will not connect back to my 3825.Its "sister" running the same config (except for inside subnets, and outside ip addresses that is) connects just fine.Here is the confi...

Hi ThereI'm trying to configure GETVPN and it's not working. Can someone advice me, if I have made a configuraiton error       I did refer to https://supportforums.cisco.com/message/3109605but I still don't understand. Please help       The loopback ...

HelloI spent a week troubleshooting an ipsec site-to-site VPN with a partner that uses Linux VPN server (freeswan probably), where phase 1 and 2 were OK but the traffic between protected networks didn't flow, no ACLs and no other restrictions. As res...

vkopelke1 by Level 1
  • 27019 Views
  • 4 replies
  • 0 Helpful votes

Hello,Yes, me again. It looks like I may have found something else wrong post-upgrade to 8.4(2) the 'same-security-traffic permit intra-interface' feature be broken unless there is a new/additional command that's needed to get this working. I did sea...

netadmin by Level 1
  • 3307 Views
  • 12 replies
  • 0 Helpful votes

We need to create a site-to-site VPN with a very large customer. They provided the following list of pre-requisites on our side (they will only use pre-defined configurations)•PSK for Internet Security Association and Key Management Protocol (ISAKMP)...

                   Is it possable to use rsa token on the ASA without setting up any other server just using the ASA, out clients use the cisco vpn client version 5.0.07.0290 and IOS 8.3(1), How would this be done?

Dear All,I am facing an issue in remote vpn .. authentication server is AAA using Radius protocol... right after an hour my client is disconnect and reason is not specified by peer ... reason is 433..... user need to connect again after an hour ... i...