VPN

Hello CommunityI was to stupid to read the datasheet and just configured AES-256 on a router with a VAM2-modul. According to the datasheet the VAM2 processes AES-256 in software. Now my question: Is there any show command to check how many (crypto-) ...

I have a 5520 that is doing IPSec, AnyConnect and Clientless VPN. I have multiple DNS suffixes in our environment. All the servers that i need access to are part of our split tunnel and split dns policy, however the only way i am able to resolve the ...

I am using VPN client version 5.0.05.0290.  After connection established, log file will have same error message continuously added (two repeats shown below).  The connection will stay up, VPN IP address and routes all look correct, but no communicati...

Hi,Is it possible to telnet to a EasyVPN remote router that is running in client mode.

Is certificate authentication the only mode where AnyConnect can be setup under windows to connect without prompting them for credentials?I don't currently have User Certificates begin issued via PKI but I do have machine certificates.. I can check t...

Hi..I have a asa 5505 with 8.3(2) software.Some time back I installed a certificate, sighned by Godaddy, and it works.. Now I need to move to another ASA, and when I look at :sh crypto ca certificatesCertificate  Status: Available  Certificate Serial...

Is it possible to install AnyConnect with Secure Desktop Advanced Endpoint Assessment so that it doesn't always trigger a UAC prompt to Windows 7 users? I do not want to disable UAC but these prompts defeat the automated nature of certificate based a...

Hi,I'm trying to configure the Anyconnect "Always-on" feature and it seems to work but for the "failure policy" even if I put "Open" the client forbid any Internet access until the client is connected....Anyone did it before? Know what's wrong?Thanks...

HI All,I would be grateful if someone would help me achieve following:Two Remote sites need to be connected via VPN.Site 1:Public IP: 210.23.149.134Local network: 10.40.1.0/24Site 2:Public IP: 210.168.66.136Local network: 192.168.200.0/24Here is the ...

Hi,There are two model for digital modem: pvdm2-32 and pvdm2-36dm.Which of them are suitable for 3845?If both of them are OK, what is the difference between them?Best wishes

Hi Gurus,We would like to implement MPLS with Ingress PE NAT, so customer with overlapping IP addresses can access the shared services, as describe in the given document:http://www.cisco.com/en/US/tech/tk648/tk361/technologies_white_paper09186a0080b4...

Hi,we need to build up a VPN access on a small business router like 1812 together with a RSA token solution.Is something like this possible or do we need an other bigger cisco hardware?Regards,Bernd

Hi,I have problem with the IPSec VPN from Juniper SSG320 going through the ISP router (2801). It seems to be unstable. Within a day, there could be a down in the VPN for about 15mins. During that time, my ping test and traceroute from the router show...