VPN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco CyberSecurity

Labels

Forum Posts

Hi, I have a tunnel vpn site-to-site with two ASA5505, the tunnel is up but when I try ping between inside lan I have in log file:Teardown ICMP connection for faddr 192.168.0.100/0 gaddr 192.168.1.159/512 laddr 192.168.1.159/512 Built outbound ICMP c...

Hi,I have a strange trouble... If I established an IPSec tunnel vs an ASA, it goes up but only works if the packet +/- under 150 bytes ... if packet size exceeded, the ASA don't send it to IPSec client; The size is related to the type of configured t...

Hi everyone,I have a cisco asa 5505 appliance. I have set up an ipsec connection for remote user to connect to it and all traffic is routed to the vpn gateway.Therefore the vpn server acts like a proxy to the vpn clients. IP compression is enabled on...

syed.alif by Level 1
  • 1780 Views
  • 0 replies
  • 0 Helpful votes

Greetings,I have some 861 routers where I want to send VoIP traffic over an EZVPN and keep all other data traffice over the WAN.  The 861 seems to have a very limited set of QoS features.  I can setup class-maps by presedence, vlan or ip rtp, and can...

I configured a remote vpn ASA 5510 using the remote vpn wizard. Users are able to get the vpn connection and access the Inside network; but UNABLE toaccess the outside network. (For Inside network, i am referring to network behind the ASA vpn; the ou...

kope by Level 1
  • 983 Views
  • 2 replies
  • 0 Helpful votes

I have a client who recently purchased an SA 540 to replace an old Sonicwall, they had a vpn connection with a medical software company on the old device.  The software company says the inside interface of the vpn needs to be a routable (outside ip) ...

chabomb24 by Level 1
  • 872 Views
  • 3 replies
  • 0 Helpful votes

Hi,Hope someone can help. I have a PIX setup for several fixed L2L IPSEC VPNs and also allowed Cisco VPN clients to VPN in. I have found that if traffic on one of the fixed VPNs doesnt match its access list it fires up a connection using the dynamic ...

matthew by Level 1
  • 1404 Views
  • 7 replies
  • 0 Helpful votes

Hi, excuse my english, i will triy expalin correctlyI have a router cisco series 1800, i confgured a Easy VPN Server to access with Cisco VPN Clients. The client access to the local LAN with problems.Later i need configured a PAT to access a server b...

When a L2L tunnel is created do the subnet masks have to match on both ends for the allowed networks that can pass through the tunnel?Here is what we allow on one end. network-object 10.49.10.0 255.255.255.0Here is what is allowed on the other end. n...

I have an ISDN network as the following:In main office PRI link.In the branches BRI links.see the attached.I want only the main office which make the calls not the opposite.I want the cost to be on the main officeI increased the idel-timeout and dele...

Top Solution Authors