VPN

Hi,I have a question,How can I configure on the ASA that vpn users (with cisco vpn client) cannot connect to the it with udp.Cisco says, By default the ipsec over udp is disabled.But not. I can connect ipsec over udp.I tried the ipsec-udp disable com...

Dear all,If any body has cisco vpn anyconnect software.

I'm using an ASA 5510 with local user authentication for VPN access. Is there a method that I can use to prompt for user password changes after a given time? If not with local accounts, what other authentication methods may be available to prompt use...

I am having a problem getting a site-to-site VPN config working. When I generate traffic from the 172.18.3.0 subnet to the 172.22.3.0 subnet I get the following error on the ASA:ASA5510# Oct 13 18:25:23 [IKEv1]: Group = 203.33.116.209, IP = 203.33.11...

Hi GuysYou have a laptop with a wifi connection on it and you connect to the Cisco VPN over the wireless connection (lets say via starbucks. When does the traffic originate from and terminate on the client. Which interface?The reason I ask is you h...

Hi all,I would like to verify sth about the remote access vpn authenticationAs I remember, I configured RA vpn on pix 6.3 version using "vpdn" command. it should able to establish the vpn only match the group name and pre-shared-key.but when I config...

Hello,I'm running into a strange problem where I have installed the VPN client (5.0.05.0290) on a several PC's and when I try to access the local network using ICMP, I cannot ping the local LAN addresses. I install the same client on another PC and I...

Hi All,my environment has the intention to replace the EOL AS5300 gateway. As the number of users are very small, i'm looking @ using 2811 router instead of AS5335 or AS5400 gateway.Existing users are dial into my AS5300 to get an IP address to acces...

We're using an ASA 7.0 to establish L2L VPN tunnels and I'd always have the remote side initiate the tunnel (say pinging our server from one of the customer's server) but I can never get the tunnel to establish by initiating it on our side (pinging t...

hi techies,i need to configure hub and spoke between 4 sites ..i have static ip on 1 site ,so that site i am using as hub and other sites are having dynamic ip.and i need to intercommunicate all sites each other through vpn thats why i am using this ...

Si,Looking for advice and config help on scenario where Branch_Office is connected to Head_Office using service provider MPLS cloud.we are looking for failover solution so that branch_office still reaches Head_office even if the MPLS link fails.On Br...