VPN

Hi all,I would like to verify sth about the remote access vpn authenticationAs I remember, I configured RA vpn on pix 6.3 version using "vpdn" command. it should able to establish the vpn only match the group name and pre-shared-key.but when I config...

Hello,I'm running into a strange problem where I have installed the VPN client (5.0.05.0290) on a several PC's and when I try to access the local network using ICMP, I cannot ping the local LAN addresses. I install the same client on another PC and I...

Hi All,my environment has the intention to replace the EOL AS5300 gateway. As the number of users are very small, i'm looking @ using 2811 router instead of AS5335 or AS5400 gateway.Existing users are dial into my AS5300 to get an IP address to acces...

We're using an ASA 7.0 to establish L2L VPN tunnels and I'd always have the remote side initiate the tunnel (say pinging our server from one of the customer's server) but I can never get the tunnel to establish by initiating it on our side (pinging t...

hi techies,i need to configure hub and spoke between 4 sites ..i have static ip on 1 site ,so that site i am using as hub and other sites are having dynamic ip.and i need to intercommunicate all sites each other through vpn thats why i am using this ...

Si,Looking for advice and config help on scenario where Branch_Office is connected to Head_Office using service provider MPLS cloud.we are looking for failover solution so that branch_office still reaches Head_office even if the MPLS link fails.On Br...

What are the best practices when dealing with ACLs?For example, if I have network 10.10.10.0/24 and in here the only outbound traffic these hosts need to reach is any destination at port 8584, then will only 1 ACL applied in the IN direction suffice?...

We are looking to purchase a router for a new project. I need to know which one will work for my application. I am going to have one internet T1 and two VPN connections to the router. Both one vpn connection will go out an ethernet interface and the ...

All,I had an ASA hardware failure. I have the replacement box in, loaded the config. I can SSH into the box as well as SSLVPN, however, IPSEC (using VPN Client 5.0) does not work. How do I fix?

Hi Cisco team,Could you pls let me know what are the possible reasons of site to site vpn intermetent disconnections between a pix appliance and vpn concentrator. This setup was working before and recently only we are facing such issues. Your inputs ...

Hello everybody,i have one question about SSL VPNs.Our Headquarter has a Cisco ASA5520 and we want to connect around 50 new customers to our office.Now i am searching for an easy deployment solution. Most of the new customers have already a firewall ...

All,I am seeing quite a few of the following denied message logs:Deny udp src inside:10.1.2.166/137 dst outside:169.254.196.189/137 by access-group "inside_access_in" 169.254.196.189 is a well known address. Why would a machine be trying to send to t...