VPN

Hi,I have a VPN on a DSL line on a remote office which connects to a Cisco ASA where our HQ is. The VPN works fine but any internet page request go over the VPN to the HQ. I would prefer if possiblt to use the routers DSL/ISP to do the internet pag...

I have a L2L tunnel created between my ASA5520 and a partner's vpn device. The tunnel will come up as long a host on my side generates interesting traffic. Problem is, a host at the remote end cannot bring up the tunnel. What could be wrong? Any ...

Dear All,I have configured L2TP over IPSec VPN in my Cisco ASA 5520 for windows vpn client.my client pool range is 192.168.15.0-192.168.15.50 255.255.255.192my internal nw range 10.138.78.0/24,10.138.79.0/24Now I want to know What access list I need ...

I am looking to have a VPN tunnel redundancy between two sites, that is if one tunnel goes down, the traffic will be routed to a backup tunnel (different site).So now we have a tunnel between site A & B, and if this tunnel was to fail, I would like t...

I am new to setting up a VPN on an ASA5510 box, and I am wondering what is the best way to do this...through the CLI or ASDM.Also during my reading, many folks mentioned using a different IP Subnet for the VPN than what is used on the inside interfac...

Hi,I have setup a VPN between a Cisco 877 DSL router to a Cisco Concentrator. It all works, and I (My PC 192.168.20.10) can access 172.30.2.10 (A PC on the 877 LAN) - great.1.) But why is it I can remove the ACL called "inbound" from the "dialer 1" ...

product - ASA firewallProblem - D:\Documents and Settings\Administrator>telnet 122.166.x.x 25Connecting To 122.166.x.x...Could not open connection to the host, on port 25: Connect failedD:\Documents and Settings\Administrator>------------------------...

Hello all,I have the AnyConnect client 2.2.0133 working well through Zone Alarm v.7. However, everytime I connect, the ASA does a version check and runs vpndownloader.exe from a temp internet location. This causes Zone Alarm to prompt the user to all...

Ive setup config for a VPN to connect to our head office Netscreen 5GT. It doesnt look like the Cisco is initiating a connection at all and Im not sure why. Here is the config, hope someone can help?

We have a few users where we just installed VPN Client 4.8.02.0010 on XP2.When trying to connect they do not get the logon prompt but instead get an error message saying 'Reason 440: Secure VPN Connection terminated by client'.Any suggestions on what...

Log from WLC:-------------RADIUS server 192.168.2.75:1812 failed to respond to request (ID 44) for client 00:13:e8:f9:ce:bd / user 'unknownLog from ACS------------2008-07-12 08:19:40.406,Alert,"A load of the kernel module '' after boot time has been ...

my FWSM module:Hardware: WS-SVC-FWM-1, 1024 MB RAM, CPU Pentium III 1000 MHzcpu utilization is very high ctx1 is taking is around 60 % 0.3% 0.3% 0.3% admin 58.0% 58.1% 58.4% ctx1