VPN

I have a situation where I need to setup a VPN L2L tunnel. The peer is using Checkpoint NG and I am using a PIX 515 (Code: 6.2(2))Now my problem is the following:The peer (Checkpoint end) needs us to 'hide' our LAN address (our LAN address is on a 10...

Someone have configuration example for the Cisco 1811 internal modem for incoming calls? I require that for remote management.

Hi All,We have a Cisco 3640 router which is now spare. It has two Ethernet interfaces physically.I would like to find out if we can configure this device for use as a VPN gateway to our network.We have a PIX firewall acting as a gateway for the netwo...

Hi,We have a Cisco 3020 VPN concentrator on which the remote access users are configured.Our requirement is like thisWe want a granular limitation on our remote access users , so that they can only access their concerned lan machines via the allowed ...

Question concerning the pix appliance and certificate servicesI have just been reading up on how the pix security appliance interacts with certificte services,according to my study guide when using certificte services with ipsec vpn,s the timezone on...

have what would appear to be a simple lan to lan vpn. I have enabled: sysopt connection permit-ipsec. The remote site works as expected - without the use of any access-list assigned to the inside interface for vpn traffic. The local site will not op...

I have a Linksys RV082 that I want to setup a VPN connection to a Cicso PIX515. I have setup a couple of sites with static IP to connect with the same PIX515. The problem is this site has a DSL connection with dynamic IP. I have found a site called N...

I have a cisco client vpn, the connection is established but I can't ping or telnet the server ( or the router ) in the other side.

I have two remote sites that connect to eachother via ipsec vpn. The tunnel between these two sites appears to be stable... pings/data move freely back and forth. However, opening share folders using the host name does not work while opening the sa...

Hi, I have a dynamic crypto map, which is applied to a Fastethernet interface - in this case everything is OK: I can connect and reach the cororate LAN. But when I apply this dynamic crypto map to a loopback interface using /32 IP vpn client connec...

If I dont want VPN users from using the Company bandwidth for Internet browsing, do I enable or disable splittunnels ?

Hello there,I am a newbie for Cisco VPN solution. I understood that Cisco usually uses GRE over IPSec. Why does it choose GRE for tunneling? Why doesn?t it use another tunneling protocols such L2TP like a MS?Please advice.Thanks in advance,Nitass