VPN

hi all i have a problem with some routing. have a 501 pix at my home site that connects to our companys system through a cisco 2621 router in a site to site vpn. i need to have traffic to a certain destination go through our companies def gateway for...

Hi,I have central router which has got four bri interface ports and four ISDN lines terminated on them.I am creating dialer interfaces to accept calls from different locations. Can I make a dialer interface member of two physical interfaces ?? if ye...

Hi guys,i've a normal situation with inside+dmz+outside with a private ip class in DMZ using static command to nat. Now i have to protect a VPN device but i can't nat it due to ipsec problem... i.e. with vpn1 i can put that host with public ip addres...

I have a PIX 501 connected to a non cisco ADSL router. My ISP has allocated me a fixed IP assigned by PPPOa of say 1.1.1.1. In addition I have a bank of 4 ips say 2.2.2.1-2.2.2.4. IP 2.2.2.1 was assigned to the outside of the PIX and 2.2.2.2 to the i...

I am currently configured for a PIX to PIX vpn (for office connectivity). Now I'd like to add the ability for clients to connect via the 4.x.x vpn client software. For security's sake I would like to require user authentication (using RADIUS and wi...

What is the recommended maximum number of users set for dial-up locally on an access server?I have about 60 accounts,does this force me to use a TACACS or RADIUS server ?Your help is greatly appreciated.

Hello All, I am wondering how I would grant access to a site to site VPN for a user that is remoting (VPN) into one side of the site to site tunnel. I want my remote users to be able to access resources at both ends of the site to site tunnel with...

Is there a way to log where users go when they are logged into the network via a 3030. I have ACS 3.2 and logging some Radius logs there. It gives me user ip and time logged in and packets in and out but not destinatin ip addresses.

Hi everybody:I want to use a vpn router for remote access.Do you know if can i use digital certificates to authenticate users with vpn client?Thank you.

Hi,Anybody know if the 6500 ACL's hardware processing will allow fragmented packets to go through by default ?

Hi!Could anybody explain what the following mean?ISAKMP (0:1): beginning Main Mode exchangesending packet to x.x.x.x my_port 500 peer_port 500 (I) MM_NO_STATEreceived packet from x.x.x.x dport 500 sport 500 Global (I) MM_NO_STATEISAKMP (0:1): Notify ...

Is there any command, so router doesn't send back Destination Unreachable messages to source denied by ACL on router.

Can anyone tell me why NAT to my DMZ fails?interface FastEthernet0 ip address xx.100.97.194 255.255.255.248 ip nat outside duplex auto speed auto no cdp enable ! interface FastEthernet1 switchport access vlan 2 no ip address no cdp enable ! interface...

Hi i have 2501 with attached octel cable (1 Serial to 8 RJ45).Now i brought 8 US ROBO 56k general fax modem and trying to configure with 2501. It always dial up and disconnects while verifying username and password. I would really appreciate if anybo...

What do the following messages indicate, and where can I find info. that will educate me on same?Warning: this may cause problems on busy networksRBXFW01# 169231: ICMP type 104 (code 47) 172.26.216.2 > 172.26.216.8 packet ignored169232: ICMP type 104...