VPN

Hi, Currently going through STIG checks.How would I go about checking the idle timeouts on my ipsec connections?In CLI I don't see one configured when I use "show run crypto ipsec"Does that mean a Default of 1 hour is in place? Thanks for your time. ...

Cisco experts,  I have been dealing with this for over 2 months at this point, and I cannot find an answer that seems to check out. I am at a loss, support seems a little slow to respond and I really need to resolve this. So I'll start with my config...

Hi, Help me out. Im just scratching my head on this one even though I've been here before.I'm STIG-ing an ASA. Where on ASDM can I configure all ISAKMP policies to use AES for IKE encryption?Or what command can I use to check that my configured set h...

Hello;I have the problem that my users need at minimum 2 attempts for a stable VPN connection with any connect.Is there a known issue for this behavior?ASA 5515-version 9.12(4), any connect 4.803052, Thanks + Sorry for my bad English, Greetings, Thom...

Hi, I have a site to site vpn from ASA to AWS. I am trying to find  commands to keep the tunnel always up. Could you advise? Thanks Loc

Hi Folks, I need to configure a VPN tunnel from my CSR in such a way that I will have to PAT all interesting traffic to the outside interface ip. So lets say my Interesting Traffic ACL is src: my-local-subnet to dest: some-hosts-on-the-cust-side. I w...

On Site A, I have two ISPs, and both of them are unstable, one ISP works sometimes, sometimes the other. 1) How can I create a S2S VPN to Site B using both these IP addresses such that, if one goes down, the others takes over. 2) I want to create Rem...

Afternoon All, I am hoping for a bit of help setting up a route based IKEv2 VPN between an ASA & IOS router.  I have setup route based IKEv1 VPN's between ASA's & IOS routers with no problem but am really struggling doing the same with IKEv2. The ASA...