VPN

Hi,i have a c3640 with a single pri.I wont configure on the ACS two User-Groups.One Group for ppp multilink, one Group for not ppp multilink.Is this possible.if yes, please send me the IOS commands and the ACS Config.Best Regards Joe

Hi,we have a problem with TACACS+ Command Authorization on a Catalyst 6000 Supervisor. Software is CatOS 6.1(2).Authorization for the command "enable" doesn´t work.After entering the command "enable" we get the message "Command authorization failed" ...

All!,We are trying to use the Windows 98 Microsoft client to bring up an IPSec VPN tunnel into a Cisco (altiga) 3060 VPN Concentrator. The PPTP will work but the IPSec process dies.Does anyone have this working in a fool-proof manner...and if so.......

We have several D-Link DI-604 routers and are having problems connecting to our PIX. I can open the IPSEC Dialer and connect with no problems... I can can get as far as opening my corporate email in outlook (about 1 min or less) and then it hangs. ...

Aamir,We terminate road warriors to PIX 515e and have softphones installed on their machines. They are able to talk to phones behind the PIX (phones ring and voice goes both ways), but when two roadwarriors dial each other, the phones ring but there ...

I have a PIX 515 setup for VPN access for external users. I'm using Win2k pro using pptp and l2tp/ipsec as a VPN client and Win2k server for Radius server. The problem I'm having is I'm getting error "691 -Access denied because username and/or passwo...

My setup is remote VPN Clients V3.5 to a central PIX515E V6.1(2).I want to assign the client VPN tunnel connections addresses from the inside LAN DHCP server, instead of using the PIX local pool.Can I do this and how?The PIX has fixed addresses on al...

I know that only four notification types (traps) are currently available (e.g. IkeTunnelStart & Stop and ipSecTunnel Start & Stop) but does anyone have any idea when the remaining ones from the draft RFC (e.g. ikeSysFailure, ikeCertCrlFailure, IkePro...

We have some people using the Cisco VPN 3000 Client and finding that their connections are dropping after a couple of minutes. MOST others are having no problems with no timeout issues. Everyone is in the same user group (we only have one) on the con...

Hello There:I got the same message ” Failed to establish a secure connection to the security gateway" trying to connect to our Cisco 515E PIX box using the two Cisco vpn 3.6 clients. I downloaded the VPN 3.6 client with the Installshield with the ...

Is it just me or is it a nightmare configuring this with any type of standard configuration. Cisco, you have samples on your web site but those aren't real world config's! Most VPN customers use NAT+FW+site to site VPN+ Client VPN. Yet try to configu...

I have the above configuration and followed to the tee the tech note:http://www.cisco.com/warp/customer/471/ios-unity.htmlI can now connect, prompted for username/password, get assigned an address and my client says its encrypting the correct packets...

When I establish a VPN trough a dialup connection everything works fine. If I connect from a PC connected to the LAN it connects but no traffic is going to the remote site and I loose all network connections on the PC which is running Windows2000 Pro...

Is it possible to setup a VPN between two routers running NAT on both ends?

i had a cisco 2600 running 12.2(5d) version, the IOS file support just IP,now i want to built a vpn between two routers (2620).so i take a 12.0(5) XK1 that support IPSec and 3DES.i instal this new IOS file in my routeur,using COPY tftp flash.....i di...