VPN

Hello Community, i worked on an issue with slow network speed between a site router (Cisco 886) and a Palo Alto Firewall for several days now. The site is using VDSL (in Germany) with about 50Mbit/s Downlink and 10Mbit/s Uplink. Here is the output f...

Hello All,   We are going to add a firewall (ASA5505) to protect our inside network but I am unsure on how to integrate with the existing router R2 (Cisco 892FSP) that is currently tunneled with remote site via l2tpv3. Since xconnect interface (f0/0)...

Hey all, I have a hostname that needs to be available both inside and outside our network on the same name.  If a user is outside our network, I need them to resolve the name to a public address even when connected via AnyConnect client.  Is there a...

Hi all, Question Nr 1: We have a edge gw configured for a customer which they are using for there office traffic to VDC at remote location through P2P. office >>>>>>>>>>>>>>>remote location ::edge gw::: internal servers in data center. Now they want ...

We have many routers that are running dmvpn connections back to corporate office. these spoke routers all have a few dmvpn tunnels. tunnels goes as follows: Main(tunnel0), Backup(tunnel1), Cellular backup(tunnel2). I have found that randomly the main...

Hello guys,  Do you have any experience with IPsec site to site VPN tunnel between Cisco device and some server(linux - which will work as FW), please share with me some information about that, as well as possible. What do you think about this solut...

Hello, I would like to know if the Real-Time-Log viewer on ASDM provides the same information as the packet capture command using cli on cisco asa when troubleshooting IPsec VPNs or does packet capture command provides bit more detailed information ...

I am trying to configure anyconnect client to authorize against an ISE server. ISE is FIPS compliant and PAP and MsChapv2 protocols are not allowed. Is there any workaround for this. TIA

I have setup a standard remote VPN so a user can remotely connect to the Firewall and have configured a NAT rule so that they have internet access using a WAN IP on the Firewall. I'm now trying to make it so that when connected to the VPN they can ac...

HI Team,               we want configure site to site configuration between Cisco 1900 series router and Fortinet firewall.Can you confirm any license required for this VPN configuration from Cisco router side and if you have same configuration pleas...

Hello, Private --PFSENSE (Public IP ) <------------Internet -----------> Bell Modem (Public IP)-----NAT-----Outside-ASA-Inside I have configured a Site-to-Site VPN between Pfsens and ASA 5505. And ASA is behind NAT With Private ip on the Outside in...

I am looking for a way to show anyconnect connection history on an IOS ISR G2.  I can get it to show the connections in the buffered or syslog but it only show by ip(i.e *Jul 25 16:51:26.655: %SSLVPN-5-SSL_TLS_CONNECT_OK: vw_ctx: UNKNOWN vw_gw: gatew...

Hello Experts, Can you guys please let me know.. if we can use a packet tracer command for VPN ACLs, Also can you guys please give me some good links for IPSEC site-site VPN documentation with NAT -T enabled. I work in a environment where we do NATTI...

Hello We have two datacenters, one Core and one a small datacenter where a few core servers and data replication occur. Users at many branch locations leverage client VPN terminating at our VPN device at Core then packets are sent to another firewall...