Wireless

Hello All,I need to know if I can somehow enable broadcast traffic just on a flexconnect AP/ group.the scenario:In a specific area of the environment, I have some Flexconnect APs. they are in the same flexconnect group and every thing is working fine...

Hello, I have a WLC-7510 version 8.5.151.0 and AP models AIR-AP1832I and IW3702.After upgrade from 8.2.151.4 to 8.5.151.0, we have the following problem:Sometimes clients are not redirected to captive web portal.Same client, same AP, sometimes it wor...

Dear All, we are looking for an automated way within Cisco Prime 3.1.6 or 3.2 to schedule the add/remove of a particular SSID within AP Groups. We plan to create individual AP groups for each building and don't want our guest SSID to be active all th...

HiI have WC-5520 and want to connect outdoor AP (AIR-AP1562i-e-k9), think it needs special configuration because it dos not connect automatically.How can i do that?   

We are deploying a new wireless environment with one centralized 9800 cloud controller and 200+ different locations with anywhere from 3 to 40 APs at each site. We would like to make the deployment as simple as possible. We plan to have two SSIDs - o...

Good afternoon;They have some experience in being able to configure the frequency coverage in the AP cisco, I have a WLC where I administer, the ground floor I can see that the coverage is very wide and from the exit to the street you can see the ssi...

Hi all,I've problem with a WLC 5520. few Clients an IP 0.0.0.0.Software Version is 8.5.140.0  Around 30% are not OK. The problem is,  we are testing on our secondary wlc all AP are moving in Secondary WLC perfectly but the few client that don't get a...

here is pretty generic case with problem:The task is to enable encryption on WAN MPLS link. Encryption adds additional payload, so communication between local WLC and authentication radius server fails and clients cannot get wifi service.My idea is t...

Hi !We have Mobility express built with 10 Access points. All APs are 1832 running 8.5 version. we observed that three APs are showing 0 clients even though the clients are sitting right below those Access Points. so we would like to limit the number...

I'm trying to track down a problem with an 8821 phone, and getting stuck trying to capture packets on the controller. (WLC5520,software version 8.5.140.0). Lightly-edited logs below:  (Cisco Controller) >debug ap packet-dump enable (Cisco Controller)...

Hi Guys,Any thoughts that my Cisco Air-AP1852I-B-K9 v02 not getting poe power from 3850 UPOE switch?I am using 1852i as ME and have tried (8.3 and 8.4,8.5) images with no luck. 3850 uPOE XE version is 3.6 

On the old Aeronet WLC you could limit the SSID a guest could use when creating the guest account.  I don't see the ability to do that now on the C9800.  How can I limit which SSID a guest account can use on the new C9800 WLC platform?  Thank you.