Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hi, I have a WLC 5508.. This WLC is connecting to the switch WS-C2960X-24PS-L.. Can you tell me the what Is the  SFP module part code on cisco WLC  that will be used to connect .

I have a problem my Wireless clients are getting put on the same IP range as the AP so I can't separate the guest network from the corp network Has anyone had this issue who could shine some light on would be very great full

Folks,              We have company laptops that are using Peap to connect to the corporate Wireless network. Recently we are getting a lot of tickets where he users are complaining that they can not connect to the wireless network. When I tell them ...

tpahuja by Level 3
  • 1384 Views
  • 3 replies
  • 0 Helpful votes

Hi All   I am new Cisco Prime NCS   Here is my requirement 1.How I can mesure the signal strenth of my wireless infrastructure(dont't have any floor map) 2.How I can mesure the user performance of my wireless infrastructure Can any one help  Thanks D...

HelloIm trying to setup some mr33s, the problem i am having is that they will not fetch the configuration that i am giving them. under config in the left panel it saysCONFIGOut of date(changed 9 minutes ago)The weird thing is that i have 3 other mr33...

jes4874 by Community Member
  • 5962 Views
  • 3 replies
  • 0 Helpful votes

Hello everyone,My 3 air-ap1815w-E can join the wlc 2504 controller without problem, but not my air-CAP702W.the log from the CAP702W:------------------------------------------------------------------------------------------------------Translating "CIS...

Solanin19 by Level 1
  • 12709 Views
  • 21 replies
  • 0 Helpful votes

Hi wireless expert:These days,i have a problem that is all clients cannot associate to 5G wifi,only 2.4G OK.There are wlc and AP module as below:WLC: 2504   ; software version:8.2.121.5AP: AP1852 i have run "debug client xx.xx.xx.xx.xx.xx" command to...

Hello all, I'm having a terribly difficult time trying to get my 1142 LAP to associate with my 3650 switch.  When I enable capwap debugging on the 3650 I see no events at all.  The AP is on the same VLAN as Wireless Mgmt interface and receives an IP ...

Garfaldo by Community Member
  • 1998 Views
  • 7 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card